ABSTRACT. Here we report a laboratory study of the effects of debris thickness, diurnally cyclic radiation and rainfall on melt rates beneath rock-avalanche debris and sand (representing typical highly permeable supraglacial debris). Under continuous, steady-state radiation, sand cover >50 mm thick delays the onset of ice-surface melting by >12 hours, but subsequent melting matches melt rates of a bare ice surface. Only when diurnal cycles of radiation are imposed does the debris reduce the longterm rate of ice melt beneath it. This is because debris >50 mm thick never reaches a steady-state heat flux, and heat acquired during the light part of the cycle is partially dissipated to the atmosphere during the nocturnal part of the cycle, thereby continuously reducing total heat flux to the ice surface underneath. The thicker the debris, the greater this effect. Rain advects heat from high-permeability supraglacial debris to the ice surface, thereby increasing ablation where thin, highly porous material covers the ice. In contrast, low-permeability rock-avalanche material slows water percolation, and heat transfer through the debris can cease when interstitial water freezes during the cold/night part of the cycle. This frozen interstitial water blocks heat advection to the ice-debris contact during the warm/day part of the cycle, thereby reducing overall ablation. The presence of metre-deep rock-avalanche debris over much of the ablation zone of a glacier can significantly affect the mass balance, and thus the motion, of a glacier. The length and thermal intensity of the diurnal cycle are important controls on ablation, and thus both geographical location and altitude significantly affect the impact of debris on glacial melting rates; the effect of debris cover is magnified at high altitude and in lower latitudes.

No abstract

No abstract

Topographic development in mountainous landscapes is a complex interplay between tectonics, climate and denudation. Glaciers erode valleys to generate headwall relief, and hillslope processes control the height and retreat of the peaks. The magnitude–frequency of these landslides and their long-term ability to lower mountains above glaciers is poorly understood; however, small, frequent rockfalls are currently thought to dominate. The preservation of rarer, larger, landslide deposits is exceptionally short-lived, as they are rapidly reworked. The 2013 Mount Haast rock avalanche that failed from the slopes of Aoraki/Mount Cook, New Zealand, onto the glacier accumulation zone below was invisible to conventional remote sensing after just 3 months. Here we use sub-surface data to reveal the now-buried landslide deposit, and suggest that large landslides are the primary hillslope erosion mechanism here. These data show how past large landslides can be identified in accumulation zones, providing an untapped archive of erosive events in mountainous landscapes.

No abstract