Coupling phase-stable single-cycle terahertz (THz) pulses to scanning tunneling microscope (STM) junctions enables spatiotemporal imaging with femtosecond temporal and Ångstrom spatial resolution. The time resolution achieved in such THz-gated STM is ultimately limited by the subcycle temporal variation of the tip-enhanced THz field acting as an ultrafast voltage pulse, and hence by the ability to feed high-frequency, broadband THz pulses into the junction. Here, we report on the coupling of ultrabroadband (1–30 THz) single-cycle THz pulses from a spintronic THz emitter (STE) into a metallic STM junction. We demonstrate broadband phase-resolved detection of the THz voltage transient directly in the STM junction via THz-field-induced modulation of ultrafast photocurrents. Comparison to the unperturbed far-field THz waveform reveals the antenna response of the STM tip. Despite tip-induced low-pass filtering, frequencies up to 15 THz can be detected in the tip-enhanced near-field, resulting in THz transients with a half-cycle period of 115 fs. We further demonstrate simple polarity control of the THz bias via the STE magnetization and show that up to 2 V THz bias at 1 MHz repetition rate can be achieved in the current setup. Finally, we find a nearly constant THz voltage and waveform over a wide range of tip–sample distances, which by comparison to numerical simulations confirms the quasi-static nature of the THz pulses. Our results demonstrate the suitability of spintronic THz emitters for ultrafast THz-STM with unprecedented bandwidth of the THz bias and provide insight into the femtosecond response of defined nanoscale junctions.

Electrochemical surface activity arises from the interaction and geometric arrangement of molecules at electrified interfaces. We present a novel electrochemical tip-enhanced Raman spectroscope that can access the vibrational fingerprint of less than 100 small, non-resonant molecules adsorbed at atomically flat Au electrodes to study their adsorption geometry and chemical reactivity as a function of the applied potential. Combining experimental and simulation data for adenine/Au(111), we conclude that protonated physisorbed adenine adopts a tilted orientation at low potentials, whereas it is vertically adsorbed around the potential of zero charge. Further potential increase induces adenine deprotonation and reorientation to a planar configuration. The extension of EC-TERS to the study of adsorbate reorientation significantly broadens the applicability of this advanced spectroelectrochemical tool for the nanoscale characterization of a full range of electrochemical interfaces.

In situ characterization of surfaces with tip-enhanced Raman spectroscopy (TERS) provides chemical and topographic information with high spatial resolution and submonolayer chemical sensitivity. To further the versatility of the TERS approach toward more complex systems such as biological membranes or energy conversion devices, adaptation of the technique to solid/liquid working conditions is essential. Here, we present a home-built side-illumination TERS setup design based on a commercial scanning tunneling microscope (STM) as a versatile, cost-efficient solution for TERS at solid/liquid interfaces. Interestingly, the results obtained from showcase resonant dye and nonresonant thiophenol monolayers adsorbed on Au single crystals suggest that excitation beam aberrations due to the presence of the aqueous phase are small enough not to limit TER signal detection. The STM parameters are found to play a crucial role for solid/liquid TERS sensitivity. Raman enhancement factors of 10(5) at μW laser power demonstrate the great potential the presented experimental configuration holds for solid/liquid interfacial spectroscopic studies.

In this work, we evaluate the dependence of tip-enhanced Raman (TER) spectra of a monolayer of thiophenol at a Au(111) electrode on the scanning tunneling microscope's tunneling current set-point and bias voltage parameters. We find an increase of the TER intensity upon set-point increase or bias decrease as expected from a gap-distance reduction. The relations obtained follow a theoretical model considering a simple gap-distance change when tuning the mentioned parameters. We find that the value of the bias voltage affects the TER intensity to a larger extent than the current set-point. Therefore it is advisable to work in a low-bias regime when aiming for ultrasensitive TER measurements.