No abstract

No abstract

No abstract

No abstract

No abstract

The standard design procedure for tube and fitting connections assumes that the connections are only subjected to non-cyclical loads. This paper presents the results of experimental tests and theoretical calculations of the moment-rotation capacities of three common connections -sleeve couplers, swivel couplers and right-angled couplers. The results show that under a cyclic side load, such as that occurring by wind loading, looseness affects the capacity of the connections. For all three types of coupler looseness is shown to be relatively high which will reduce the stiffness of the connection under side loads. For sleeve couplers the effects of axial load in the tubes also affects the coupler stiffness and the maximum bending capacity of the joint. This implies that the common European code BS EN 74-1 for the connection should be changed to consider the loss in stiffness and maximum side load capacity under axial loads and looseness which are ignored in the standard. The standard assumption for right-angled and swivel couplers is that the connection can be assumed to be rigid about an axis normal to the plane containing the two tubes being joined. This is shown to be incorrect as the connections are shown to have stiffnesses about this axis which is of a similar order to the stiffnesses about the other axes.

This paper investigates the effect of using near-surface mounted carbon fiber-reinforced polymer (NSM-CFRP) on the shear strengthening of rectangle beams with low strength concrete (f′c = 17 MPa), medium strength concrete (f′c = 32 MPa), and high strength concrete (f′c = 47 MPa). The experimental program was performed by installing NSM-CFRP strips vertically in three different configurations: aligned with the internal stirrups, one vertical NSM-CFRP strip between every two internal stirrups, and two vertical NSM-CFRP strips between every two internal stirrups. All tested beams were simply supported beams and tested under a three-point loading test. The experimental results were compared with the theoretical capacities that were calculated according to the ACI 440.2R-17 and finite element analysis (FEA) that was conducted using ABAQUS software to simulate the behavior of all beams. The experimental results indicated that using NSM-CFRP limited the failure mode of all beams to pure shear failure with no debonding or rapture of the carbon strips. Moreover, the use of NSM-CFRP proved its efficiency by increasing the shear capacity of all beams by a range of 4% to 66%, in which the best enhancement was recorded for the case of using two unaligned NSM-CFRP strips. In general, the experimental shear capacities increased with the increase in the compressive strength of all beams. On the other hand, the ACI 440.2R-17 was conservative in predicting the theoretical shear capacities, and the FEA results agreed well with the experimental results.

No abstract