In the heat «cooling» investigated the temperature dependence of the specific heat capacity and thermodynamic functions doped strontium alloy AK1М2 in the range 298,15—900 K. Mathematical models are obtained that describe the change in these properties of alloys in the temperature range 298.15—900 K, as well as on the concentration of the doping component. It was found that with increasing temperature, specific heat capacity, enthalpy and entropy alloys increase, and the concentration up to 0.5 wt.% of the alloying element decreases. Gibbs energy values have an inverse relationship, i.e., temperature — decreases the content of alloying component — is up to 0.5 wt.% growing.
The temperature dependence of the specific heat capacity and change in the thermodynamic functions of strontium-alloyed ultrahigh-purity aluminum base AK1M2 alloy have been studied in “cooling” mode over the 298.15–900 K range. Mathematical models describing the evolution of these properties of the alloys in the abovementioned temperature range with change in alloying addition concentration have been obtained. The heat capacity, enthalpy and entropy of the alloys increase with temperature, decrease with an increase in the alloying addition concentration to 0.5 wt.% and grow with a further increase in the alloying addition concentration. The Gibbs energy of the alloys has an inverse dependence: it decreases with an increase in temperature and grows with an increase in the alloying addition concentration to 0.5 wt.%.
Известно, что технический алюминий с повышенным содержанием железа, кремния и других примесей изза низких эксплуатационных характеристик не может найти применение в промышленности. Отсюда разработка новых составов сплавов на основе такого металла является весьма актуальной задачей. Одним из перспективных составов на диаграмме алюминий-железо является эвтектика (α-Al+Al 3 Fe), которая, имея минимальный интервал кристаллизации, соответствует содержанию железа 2.18%(мас.). Данный состав был принять нами в качестве модельного сплава и подвергался модифицированию литием. Теплоёмкость является важнейшей характеристикой веществ и по её изменению от температуры можно определить тип фазового превращения, температуру Дебая, энергию образования вакансий, коэффициент электронной теплоёмкости и другие свойства. В настоящей работе теплоёмкость сплава АЖ2.18 с литием определялась в режиме «охлаждения» по известной теплоёмкости эталонного образца из меди. Для чего обработкой кривых скорости охлаждения образцов из сплава АЖ2.18 с литием и эталона получены полиномы, описывающие их скорости охлаждения. Далее по экспериментально найденным величинам скоростей охлаждения эталона и образцов из сплавов, зная их массы, были установлены полиномы температурной зависимости теплоемкости сплавов и эталона, которые описываются четырёхчленным уравнением. Используя интегралы от удельной теплоемкости, были установлены модели температурной зависимости изменения энтальпии, энтропии и энергии Гиббса. Полученные зависимости показывают, что с ростом температуры теплоёмкость, энтальпия и энтропия сплавов увеличиваются, а значения энергии Гиббса уменьшается. При этом добавки лития незначительно увеличивают теплоёмкость, энтальпию и энтропию исходного сплава АЖ2.18 и не влияют на величину энергии Гиббса.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.