Collagen is widely used in tissue engineering because it can be extracted in large quantities, and has excellent biocompatibility, good biodegradability, and weak antigenicity. In the present study, we isolated printable collagen from bovine Achilles tendon and examined the purity of the isolated collagen using sodium dodecyl sulfate polyacrylamide gel electrophoresis. The bands obtained corresponded to α, α and β chains with little contamination from other small proteins. Furthermore, rheological measurements of collagen dispersions (60 mg per ml of PBS) at pH 7 revealed values of viscosity of 35.62 ± 1.42 Pa s at shear rate of 10 s - 1 and a shear thinning behavior. Collagen gels and solutions can be used for building scaffolds by three-dimensional (3D) printing. After designing and fabricating a low-cost 3D printer we assayed the collagen printing and obtaining 3D printed scaffolds of collagen at pH 7. The porosity of the scaffold was 90.22% ± 0.88% and the swelling ratio was 1437% ± 146%. The microstructure of the scaffolds was studied using scanning electron microscopy, and a porous mesh of fibrillar collagen was observed. In addition, the 3D printed collagen scaffold was not cytotoxic with cell viability higher than 70% using Vero and NIH 3 T3 cells. In vitro evaluation using both cells lines demonstrated that the collagen scaffolds had the ability to support cell attachment and proliferation. Also a fibrillar collagen mesh was observed after two weeks of culture at 37 °C. Overall, these results are promising since they show the capability of the presented protocol to obtain printable fibrillar collagen at pH 7 and the potential of the printing technique for building low-cost biocompatible 3D plotted structures which maintained the fibrillar collagen structure after incubation in culture media without using additional strategies as crosslinking.

No abstract

the proposed decellularization protocol was correct, and was verified by an absence of cells. The hepatic matrix had preserved vascular and bile ducts with a suitable three-dimensional architecture permitting further cell seeding.

Context Coriandrum sativum L. (Apiaceae) (coriander) is an herb grown throughout the world as a culinary, medicinal or essential crop. In traditional medicine, it is used for the relief of anxiety and insomnia. Systemic hydro-alcoholic and aqueous extract from aerial parts and seeds had anxiolytic and sedative action in rodents, but little is known about its central effect in chicks. Objective To study the effects of intracerebroventricular administration of essential oil from coriander seeds and its major component linalool on locomotor activity and emotionality of neonatal chicks. Materials and methods The chemical composition of coriander essential oil was determined by a gas-chromatographic analysis (480% linalool). Behavioural effects of central administration of coriander oil and linalool (both at doses of 0.86, 8.6 and 86 mg/chick) versus saline and a sedative diazepam dose (17.5 mg/chick, standard drug) in an open field test for 10 min were observed. Results Doses of 8.6 and 86 mg from coriander oil and linalool significantly decreased (p50.05) squares crossed number, attempted escapes, defecation number and distress calls, and significantly increased (p50.05) the sleeping posture on an open field compared with saline and were similar to the diazepam group. Discussion and conclusion The results indicate that intracerebroventricular injection of essential oil from Coriandrum sativum seeds induced a sedative effect at 8.6 and 86 mg doses. This effect may be due to monoterpene linalool, which also induced a similar sedative effect, and, therefore, could be considered as a potential therapeutic agent similar to diazepam. ARTICLE HISTORY

No abstract

No abstract

No abstract

The composite obtained displayed promising biomedical applications through the simple method of powder metallurgy. Additionally, these findings provide an in vitro proof for adequate biocompatibility of titanium-hydroxyapatite composite sintered at 800°C.