No abstract

Microcellular foam is a polymeric foam with bubble sizes of 10 microns or less that is produced by saturating a polymer with gas and then utilizing the thermodynamic instabilities that result when the polymer is heated and the pressure is reduced to nucleate the cells. A model for the nucleation of microcellular foam in amorphous polymers with additives has been developed. The nucleation process depends on the solubility, concentration, and interfacial energy of any additives present. At very low levels, additives in solution act to increase the free volume of the polymer, resulting in homogeneous nucleation within the free volume Well above the solubility limit, heterogeneous nucleation dominates, as it lowers the activation energy for nucleation to levels below that for homogeneous nucleation. In the vicinity of the solubility limit of the additive, these two nucleation mechanisms compete. The polystyrene‐zinc stearate system has been chosen for experimental evaluation.

A novel process to produce microcellular thermoplastic parts is described. This is achieved by integrating the deformation process in the foaming cycle in such a way that the cell nucleation and growth processes are effectively uncoupled from deformation. The nitrogen-polystyrene system is studied and the relationships between the essential process parameters are established. It is experimentally shown that the pressures associated with deformation do not reduce the number of bubbles nucleated. The process synthesized is demonstrated by making a microcellular polystyrene container.

Microllular plastics are cellular polymers characterized by cell densities greater than 109 cells/cm3 and cells smaller than 10 μm. One of the critical steps in the continuous production of microcellular plastics is the promotion of high cell nucleation rates in a flowing polymer matrix. These high nucleation rates can be achieved by first forming a polymer/gas solution followed by rapidly decreasing the solubility of gas in the polymer. Since, in the processing range of interest, the gas solubility in the polymer decreases as the pressure decreases, a rapid pressure drop element, consisting of a nozzle, has been employed as a continuous microcellular nucleation device. In this paper, the effects of the pressure drop rate on the nucleation of cells and the cell density are discussed. The experimental results indicate that both the magnitude and the cell density are discussed. The experimental results indicate that both the magnitude and the rate of pressure drop play a strong role in microcellular processing. The pressure phenomenon affects the thermodynamic instability induced in the polymer/gas solution and the competition between cell nucleation and growth.