Megasplay faults, very long thrust faults that rise from the subduction plate boundary megathrust and intersect the sea floor at the landward edge of the accretionary prism, are thought to play a role in tsunami genesis. We imaged a megasplay thrust system along the Nankai Trough in three dimensions, which allowed us to map the splay fault geometry and its lateral continuity. The megasplay is continuous from the main plate interface fault upwards to the sea floor, where it cuts older thrust slices of the frontal accretionary prism. The thrust geometry and evidence of large-scale slumping of surficial sediments show that the fault is active and that the activity has evolved toward the landward direction with time, contrary to the usual seaward progression of accretionary thrusts. The megasplay fault has progressively steepened, substantially increasing the potential for vertical uplift of the sea floor with slip. We conclude that slip on the megasplay fault most likely contributed to generating devastating historic tsunamis, such as the 1944 moment magnitude 8.1 Tonankai event, and it is this geometry that makes this margin and others like it particularly prone to tsunami genesis.

in an episodic development of the margin and produced a discontinuous record of convergence history within the accretionary wedge.

No abstract

The location of the Integrated Ocean Drilling Program's (IODP) Nankai Trough Seismogenic Zone Experiment (NanTroSEIZE) was based on regional two-dimensional seismic reflection surveys carried out by the Japan Agency for Marine-Earth Science and Technology (JAMSTEC). Final site locations were chosen based on a three-dimensional (3-D) seismic reflection survey acquired across the seaward margin of Kumano Basin and the accretionary prism from the basin to the deformation front. This survey covered a region 12 km wide (approximately parallel to the regional structural strike) and 56 km long (approximately perpendicular to the regional strike) and provided detailed images of the structure and seismic stratigraphy of the drill sites. Sites were drilled in the frontal thrust zone at the toe of the accretionary prism, the frontal region of the megasplay fault zone, and the forearc basin. The 3-D seismic data volume images a main frontal thrust at the prism toe with the hanging wall thrust at least 7.5 km seaward over the trench. This configuration is different from that in other parts of the Nankai prism. At the shallow end of the megasplay, the data images a complex thrust system that truncates older structures in the underlying accretionary prism and shows that the hanging wall block has overridden more than 1250 m of young slope sediments. At the forearc basin site, we interpret landward-dipping forearc basin strata onlapping older slope sediments, which in turn overlie an older part of the accretionary prism.

[1] Log and core data document gas saturations as high as 90% in a coarse-grained turbidite sequence beneath the gas hydrate stability zone (GHSZ) at south Hydrate Ridge, in the Cascadia accretionary complex. The geometry of this gassaturated bed is defined by a strong, negative-polarity reflection in 3D seismic data. Because of the gas buoyancy, gas pressure equals or exceeds the overburden stress immediately beneath the GHSZ at the summit. We conclude that gas is focused into the coarse-grained sequence from a large volume of the accretionary complex and is trapped until high gas pressure forces the gas to migrate through the GHSZ to seafloor vents. This focused flow provides methane to the GHSZ in excess of its proportion in gas hydrate, thus providing a mechanism to explain the observed coexistence of massive gas hydrate, saline pore water and free gas near the summit.

Quake Control Large earthquakes occur at the margins of two colliding plates, where one plate subducts beneath the other at a shallow angle. These megathrust earthquakes often cause destructive tsunamis owing to the displacement of large volumes of water at the fault along the plate boundary. Two related studies of the seismic structure of subduction zones attempt to reveal the underlying mechanisms of megathrust earthquakes (see the Perspective by Wang ). Kimura et al. (p. 210 ) compared seismic reflection images and microearthquake locations at the Philippine Sea plate where it subducts obliquely beneath Japan. The locations of repeating microearthquakes correspond to active transfer of material from the subducting plate to the continent—a process only previously assumed from exhumed metamorphic rocks. Dean et al. (p. 207 ) observe an expansive structure in the sea-floor sediment near the location of the 2004 and 2005 Sumatra earthquakes in Indonesia that suggests sediment properties may influence the magnitude of megathrust ruptures and their subsequent tsunamis.

No abstract

No abstract