Методом просвечивающей электронной микроскопии исследовано зеренное и структурно-фазовое состояние технически чистого титана ВТ1-0 в ультрамелкозернистом состоянии, ионно-легированного алюминием. Ультрамелкозернистое состояние (0,2 мкм) было получено методом многократного одноосного прессования (abc-прессование) с последующей многоходовой прокаткой в ручьевых валках при комнатной температуре и дорекристаллизационным отжигом при 573 К в течение 1 ч. Имплантация осуществлялась на источнике MEVVA V.RU при комнатной температуре, времени имплантации 5,25 ч и дозе облучения 1⋅10 18 ион/см 2. Для анализа химического состава имплантированных материалов использованы оже-электронный спектрометр 09ИОС. Изучение образцов проводилось в двух состояниях: 1) до имплантации (исходное состояние) и 2) после имплантации на расстоянии 70-100 нм от поверхности образца. Получен концентрационный профиль алюминия по мере удаления от поверхности имплантированного α-Ti. Установлено, что максимальная концентрация алюминия составляет 70 ат. %, толщина имплантированного слоя-200 нм. Построены функции распределения зерен по размерам, определен средний размер зерна, рассчитан коэффициент анизотропии зерен до и после имплантации. Установлено, что после ионного воздействия наблюдается уменьшение коэффициента анизотропии более чем в 2 раза в основном за счет уменьшения продольного размера зерен. Установлено, что имплантация алюминия в титан привела к образованию целого набора фаз, обладающих различными кристаллическими решетками, а именно β-Ti, TiAl 3 , Ti 3 Al, TiC и TiO 2. Определены места их локализации, размеры, плотность их распределения и объемные доли. Установлено, что фазы TiAl 3 и Ti 3 Al являются упорядоченными и формируются в условиях ионного облучения по границам зерен α-Ti. Показано, что имплантация приводит к увеличению скалярной плотности дислокаций и внутренних напряжений, создаваемых дислокационной структурой, но не приводит к поляризации дислокационной структуры. Ключевые слова: имплантация, технически чистый титан, УМЗ-состояние, фазовый состав, частица, кристаллическая решетка, дислокационная структура, скалярная плотность дислокаций, внутренние напряжения, зерно, предел текучести, упрочнение.