A series of Fe-18Cr-18Mn-N-C alloys was produced and evaluated to determine their mechanical and hardness properties. In one group, different levels of nitrogen and carbon were added to a base composition of Fe-18Cr-18Mn. The base Fe-18Cr-18Mn alloy had a fcc-bcc duplex microstructure. The addition of nitrogen and carbon stabilised the fcc phase. These alloys had increasing room temperature hardness, strength, and failure energy with increasing interstitial concentrations. At cryogenic and elevated temperatures, these alloys had increasing hardness (and by implication, increased strength) with increasing interstitial concentrations. In a second group, different levels of nitrogen and carbon were added to the base Fe-18Cr-18Mn composition to which minor solid solution additions of silicon, molybdenum, and nickel had been added. Minor alloy additions made only nominal improvement to mechanical and hardness properties. Nitrogen remained interstitial. However, these minor solid solution additions reduced carbon solubility resulting in the formation of M 23 C 6 precipitates that, while increasing alloy hardness and strength, greatly reduced fracture toughness. The present study suggests that replacing nickel with manganese in stainless steels results not only in more economical alloys but also in alloys with higher strength and hardness.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.