Наведено результати гідравлічних досліджень експлуатаційних режимів роботи водогону на ділянці від водозабору до підвищувальної насосної станції. Визначено та обґрунтовано режим експлуатації водогону на підставі гідравлічних досліджень і експлуатаційних показників роботи свердловин. Через наявність рельєфного водорозділу траса водогону за довжиною знижується від водозабору на 52 м до підвищувальної насосної станції. З'ясовано експлуатаційний режим роботи насосів свердловин включно з фактичним їх напором. Встановлено, що експлуатаційний напір насосів свердловин, який становить 30 м, є надлишковим для цих умов. Отож, доцільно замінити та модернізувати насоси свердловин на насоси з нижчим напором, та вищим коефіцієнтом корисної дії. З'ясовано наявність безнапірної і напірної течії води у водогоні залежно від величини подачі води. Встановлено, що безнапірна течія характерна для витрат води, близьких до середньогодинних у діапазоні 3000-4000 м3/год. За більших витрат води у водогоні наявний напірний режим течії. Визначено необхідний напір насосів свердловин з урахуванням режиму роботи водогону. Величина подачі води у водогоні насосами свердловин водозабору і подача води підвищувальною насосною станцією переважно не збігаються, тому тиск води у водогоні змінний. Обґрунтовано доцільність експлуатації свердловин у режимі з перервою роботи насосів свердловин на 2 год за добу. Відтак водогін, у межах водозабірних свердловин, спорожниться і режим роботи свердловинних насосів буде в області малих напорів та більшої подачі води. Внаслідок цього зменшиться витрата електроенергії. Виконано порівняння економічності експлуатації насоса ЕЦВ 12-255-30 та насоса SP 270-1L-G. Запропонований режим роботи свердловин дає можливість зменшення експлуатаційних витрат електроенергії.
The accuracy of water flow rate measurement with an ultrasonic flow meter (UFM) is affected by pipeline conditions. On water pipelines, there is often no the required length of direct section, required by the device passport or regulatory documents. Therefore, we conducted experiments using UFM to measure water flow rate in the zone of influence of non-direct sections of the water pipeline. The flow rate was measured in two planes of the pipeline with an offset of 90 o and the average value was taken. Thus, it was expected to take into account the average water velocity for the asymmetric velocity profile. The results of water flow rate measuring with UFM on short direct sections of the water pipeline, limited by pipeline bends sudden constriction of the pipeline, are presented. The greatest influence on the UFM measurement error is the 90 o pipeline bends.
Analytical hydraulic researches of the circulating water cooling system of the power unit of a thermal power plant with Heller cooling tower have been performed. Analytical studies were performed on the basis of experimental data obtained during the start-up tests of the circulating water cooling system of the “Hrazdan-5” power unit with a capacity of 300 MW. Studies of the circulating water cooling system were carried out at an electric power of the power unit of 200 - 299 MW, with a thermal load of 320 - 396 Gcal/hr. By circulating pumps (CP), water mixed with condensate is fed to the cooling tower, from where it is returned through the turbine for spraying by nozzles in the turbine steam condenser. An attempt to increase the water supply to the condenser by increasing the size of the nozzles did not give the expected results. The amount of the water supply to the circulating pumping station depends on the pressure loss in the circulating water cooling system. The highest pressure losses are in hydro turbines (HT), which are part of the circulating pumping station. Therefore, by adjusting the load of the hydro turbine, with a decrease in water pressure losses, you can increase the water supply by circulating pumps to the condenser. Experimental data and theoretical dependences were used to calculate the changed hydraulic characteristics of the circulating water cooling system. As a result of reducing the pressure losses in the section of the hydro turbine from 1.04 to 0.15 kgf/cm2, the dictating point for the pressure of circulating pumping station will be the turbine steam condenser. The thermal power plant cooling tower is designed to service two power units. Activation of the peak cooler sectors of the cooling tower gives a reduction of the cooled water temperature by 2-4 °С only with the spraying system.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.