No abstract

A series of epoxidized oils were prepared from rubber seed, soybean, jatropha, palm, and coconut oils. The epoxy content varied from 0.03 to 7.4 wt %, in accordance with the degree of unsaturation of the oils (lowest for coconut, highest for rubber seed oil). Bulk polymerization/curing of the epoxidized oils with triethylenetetramine (in the absence of a catalyst) was carried out in a batch setup (1 : 1 molar ratio of epoxide to primary amine groups, 100°C, 100 rpm, 30 min) followed by casting of the mixture in a steel mold (180°C, 200 bar, 21 h) and this resulted in cross‐linked resins. The effect of relevant pressing conditions such as time, temperature, pressure, and molar ratio of the epoxide and primary amine groups was investigated and modeled using multivariable nonlinear regression. Good agreement between experimental data and model were obtained. The rubber seed oil‐derived polymer has a Tg of 11.1°C, a tensile strength of 1.72 MPa, and strain at break of 182%. These values are slightly higher than for commercial epoxidized soybean oil (Tg of 6.9°C, tensile strength of 1.11 MPa, and strain at break of 145.7%). However, the comparison highlights the potential for these novel resins to be used at industrial/commercial level. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 42591.

Methyl oleate, methyl linoleate, and jatropha oil were fully epoxidized using in situ-generated performic acid. The epoxidized compounds were further reacted with furfurylamine in a solvent-free reaction to obtain furan-functionalized fatty esters which, then, functioned as oligomers for a network preparation. Thermoreversible crosslinking was obtained through a (retro) Diels–Alder reaction with bismaleimide, resulting in the formation of a brittle network for furan-functionalized methyl linoleate and jatropha oil. The furan-functionalized fatty esters were mixed with alternating (1,4)-polyketone reacted with furfurylamine (PK-Furan) for testing the mechanical and self-healing properties with DMTA and DSC, respectively. Full self-healing properties were found, and faster thermoreversibility kinetics were observed, compared to PK-Furan.