Surface roughness and burr formation are among the most important surface quality metrics which determine the quality of the fabricated parts. High precision machined microparts with complex features require micromachining process to achieve the desired yet stringent surface finish and dimensional accuracy. In this research, the effect of cutting speed (m/min), feed rate (µm/tooth), depth of cut (µm) and three types of tool coating (AlTiN, nACo and TiSiN) were analyzed to study their effect on surface roughness and burr formation during the micromachining of Inconel 718. The analysis was carried out using an optical profilometer, scanning electron microscope and statistical technique. Machining tests were performed at low speed with a feed rate (µm/tooth) below the cutting-edge radius for 10 mm cutting length using a carbide tool of 0.5 mm diameter on a CNC milling machine. From this research, it was determined that the depth of cut was the main factor affecting burr formation, while cutting velocity was the main factor affecting the surface roughness. In addition, cutting tool coating did not significantly affect either surface roughness or burr formation due to the difference in coefficient of friction. The types of burr formed during micromilling of Inconel 718 were mainly influenced by the depth of cut and feed rate (µm/tooth) and were not affected by the cutting velocity. It was also concluded that the results for the surface finish at low-speed machining are comparable to that of transition and high-speed machining, while the burr width found during confirmation experiments at low-speed machining was also within an acceptable range.

GLARE laminates are multi-layered metal-composite materials created from bonding sheets of metallic alloys with carbon or glass fibre layers. The application of hybrid-conventional machining processes such as ultrasonic-assisted drilling (UAD) is becoming of great interest to the aerospace industry due to its capability in reducing the cutting forces and tool wear which are directly responsible for drilling-induced delamination. There is rich literature on the conventional drilling (CD) of GLARE, but no work reported using UAD process. This study will fill this gap and investigate the UAD of GLARE laminates using an indigenously developed UAD system. The influence of spindle speed and feed rate on thrust force and surface roughness metrics (Ra and Rz) were investigated under CD and UAD regimes. The quality of the borehole and damage mechanisms in the laminate constituents was examined using scanning electron microscopy (SEM). The contribution of the drilling parameters on the measured outputs was further evaluated using the analysis of variance (ANOVA) statistical analysis. It was found that UAD resulted in a significant reduction in thrust force by up to 65% while surface roughness metrics Ra and Rz were unaffected by the type of drilling process used. SEM analysis showed irregular and fuzzier surfaces in glass fibre layers in holes machined using UAD due to the longitudinal vibration of the tool.