Fused deposition modelling (FDM) has been widely used in medical appliances, automobile, aircraft and aerospace, household appliances, toys, and many other fields. The ease of processing, low cost and high flexibility of FDM technique are strong advantages compared to other techniques for thermoelectric polymer composite fabrication. This research work focuses on the effect of two crucial printing parameters (infill density and printing pattern) on the tensile, dynamic mechanical, and thermoelectric properties of conductive acrylonitrile butadiene styrene/zinc oxide (CABS/ZnO composites fabricated by FDM technique. Results revealed significant improvement in tensile strength and Young’s modulus, with a decrease in elongation at break with infill density. Improvement in dynamic storage modulus was observed when infill density changed from 50% to 100%. However, the loss modulus and damping factor reduced gradually. The increase of thermal conductivity was relatively smaller compared to the improvement of electrical conductivity and Seebeck coefficient, therefore, the calculated figure of merit (ZT) value increased with infill density. Line pattern performed better than rectilinear, especially in tensile properties and electrical conductivity. From the results obtained, FDM-fabricated CABS/ZnO showed much potential as a promising candidate for thermoelectric application.
In the roadmaps of the automotive industry, the electric vehicle (EV) is regarded as a crucial technology for the future of automotive power systems. The EV has become a top priority of major global car manufacturers and is expected to disrupt the road transportation sector. In Malaysia and Indonesia, EVs just started as an important force. However, in Malaysia, the lack of EV infrastructure, along with its strong dependency on fossil fuels, poses an enormous challenge. The situation is very similar in Indonesia. Indonesia has huge potential as Southeast Asia’s largest vehicle market and a major nickel producer, an important EV battery ingredient. Therefore, this article addresses several critical issues in implementing EVs in Malaysia and Indonesia. In preparing this review, we have thoroughly selected very important EV keywords that are frequently asked. We have also interviewed some prominent figures in the field of EV to address the most critical aspects worth including in the paper. In doing so, we plan to provide content that will be beneficial not only to the academic world but also to the automotive industry in general. Firstly, a summary of the EV adoption scenario in each country was presented. Afterwards, the types of EVs and battery capacities available in both countries were explained. The next section focused on the adoption rate of EVs, followed by the discussion of EVs charging infrastructure. In addition to that, issues pertaining to vehicle tax credit were also addressed. The opportunities and challenges of EV were then addressed in depth before concluding remarks were given.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.