Assistive robotic arms have shown the potential to improve the quality of life of people with severe disabilities. However, a high performance and intuitive control interface for robots with 6-7 DOFs is still missing for these individuals. An inductive tongue computer interface (ITCI) was recently tested for control of robots and the study illustrated potential in this field. The paper describes the investigation of the possibility of developing a high performance tongue based joystick-like controller for robots through two studies. The first compared different methods for mapping the 18 sensor signals to a 2D coordinate, as a touchpad. The second evaluated the performance of a novel approach for emulating an analog joystick by the ITCI based on the ISO9241-411 standard. Two subjects performed a multi-directional tapping test using a standard analog joystick, the ITCI system held in hand and operated by the other hand, and finally by tongue when mounted inside the mouth. Throughput was measured as the evaluation parameter. The results show that the contact on the touchpads can be localized by almost 1 mm accuracy. The throughput of ITCI system for the multi-directional tapping test was 0.82 bps while keeping it in the hand and 0.73 bps when using it inside the mouth, comparing to 1.99 bps throughput of the analog joystick.

Individuals with tetraplegia have a challenging life due to a lack of independence and autonomy. Assistive robots have the potential to assist with the activities of daily living and thus improve the quality of life. However, an efficient and reliable control interface for severely disabled individuals is still missing. An intraoral tongue-computer interface (ITCI) for people with tetraplegia has previously been introduced and tested for controlling a robotic manipulator in a study deploying discrete tongue robot mapping. To improve the efficiency of the interface, the current study proposed the use of virtual buttons based on the ITCI and evaluated them in combination with a joystick-like control implementation, enabling continuous control commands. Twelve able-bodied volunteers participated in a three-day experiment. They controlled an assistive robotic manipulator through the tongue to perform two tasks: Pouring water in a cup (PW) and picking up a roll of tape (PUT). Four different tongue-robot mapping methods were compared. The results showed that using continuous commands reduced the task completion time by 16% and the number of commands of the PUT test by 20% compared with discrete commands. The highest success rate for completing the tasks was 77.8% for the PUT test and 100% for the PW test, both achieved by the control methods with continuous commands. Thus, the study demonstrated that incorporating continuous commands can improve the performance of the ITCI system for controlling robotic manipulators.

Spinal cord injury can leave the affected individual severely disabled with a low level of independence and quality of life. Assistive upper-limb exoskeletons are one of the solutions that can enable an individual with tetraplegia (paralysis in both arms and legs) to perform simple activities of daily living by mobilizing the arm. Providing an efficient user interface that can provide full continuous control of such a device—safely and intuitively—with multiple degrees of freedom (DOFs) still remains a challenge. In this study, a control interface for an assistive upper-limb exoskeleton with five DOFs based on an intraoral tongue-computer interface (ITCI) for individuals with tetraplegia was proposed. Furthermore, we evaluated eyes-free use of the ITCI for the first time and compared two tongue-operated control methods, one based on tongue gestures and the other based on dynamic virtual buttons and a joystick-like control. Ten able-bodied participants tongue controlled the exoskeleton for a drinking task with and without visual feedback on a screen in three experimental sessions. As a baseline, the participants performed the drinking task with a standard gamepad. The results showed that it was possible to control the exoskeleton with the tongue even without visual feedback and to perform the drinking task at 65.1% of the speed of the gamepad. In a clinical case study, an individual with tetraplegia further succeeded to fully control the exoskeleton and perform the drinking task only 5.6% slower than the able-bodied group. This study demonstrated the first single-modal control interface that can enable individuals with complete tetraplegia to fully and continuously control a five-DOF upper limb exoskeleton and perform a drinking task after only 2 h of training. The interface was used both with and without visual feedback.

No abstract

Wheelchair mounted upper limb exoskeletons offer an alternative way to support disabled individuals in their activities of daily living (ADL). Key challenges in exoskeleton technology include innovative mechanical design and implementation of a control method that can assure a safe and comfortable interaction between the human upper limb and exoskeleton. In this article, we present a mechanical design of a four degrees of freedom (DOF) wheelchair mounted upper limb exoskeleton. The design takes advantage of non-backdrivable mechanism that can hold the output position without energy consumption and provide assistance to the completely paralyzed users. Moreover, a PD-based trajectory tracking control is implemented to enhance the performance of human exoskeleton system for two different tasks. Preliminary results are provided to show the effectiveness and reliability of using the proposed design for physically disabled people.