Polyethylene sampler uptake was compared to polychaete uptake to assess bioavailability of polychlorinated biphenyls (PCBs) from resuspended sediments. New Bedford Harbor (MA, U.S.) sediment contaminated with PCBs, was resuspended under four different water column oxidation conditions: resuspension alone, resuspension under aeration, resuspension under helium, and no resuspension (control). Residuals were tested for differences in PCB availability to the marine polychaete Nereis virens and to polyethylene (PE) passive samplers. Few significant differences between the four resuspension treatments were observed: under aeration, three of 23 PCBs analyzed showed significant increases in polychaete accumulation, while resuspension alone showed increased concentrations in PE samplers for nine of 23 PCBs. Otherwise, no differences were observed and overall we concluded that resuspension had no effect on residual PCB availability. The relationship between disequilibrium-corrected PE and lipid-normalized polychaete PCB concentrations was nearly 1:1 with a strong linear correlation (r2 = 0.877), demonstrating PCBs are taken up similarly into PE and lipid. On average, PE samplers suggested dissolved PCB concentrations 3.6 times greater than those calculated with lipid-water partitioning, though on a congener-specific basis this was only observed for lower chlorinated PCBs; for higher chlorinated PCBs, PE-water partitioning suggested lower dissolved concentrations than those based on lipid. Organic carbon (OC)-water and OC and black carbon combined (OC+BC)-water partitioning suggested average dissolved concentrations 29 and 10 times greater, respectively, than those estimated with lipid-water partitioning. This demonstrates that PE-measured porewater concentrations can provide a more reliable estimate of bioavailability than sediment geochemistry.

We report on a procedure using powdered coconut charcoal to sequester organic contaminants and reduce toxicity in sediments as part of a series of toxicity identification and evaluation (TIE) methods. Powdered coconut charcoal (PCC) was effective in reducing the toxicity of endosulfan-spiked sediments by 100%. Powdered coconut charcoal also was effective in removing almost 100% of the toxicity from two field sediments contaminated with polychlorinated biphenyls (PCBs) and polycyclic aromatic hydrocarbons (PAHs). Powdered coconut charcoal did not change the toxicity of ammonia or metal-spiked sediments; however, there was some quantitative reduction in the concentrations of free metals (element specific) in metal-spiked sediments. Powdered coconut charcoal is an effective, relatively specific method to sequester and remove toxicity from sediments contaminated with organic contaminants.

As the use of single-walled carbon nanotubes (SWNTs) increases over time, so does the potential for environmental release. This research aimed to determine the toxicity, bioavailability, and bioaccumulation of SWNTs in marine benthic organisms at the base of the food chain. The toxicity of SWNTs was tested in a whole sediment exposure with the amphipod Ampelisca abdita and the mysid Americamysis bahia. In addition, SWNTs were amended to sediment and/or food matrices to determine their bioavailability and bioaccumulation through these routes in A. abdita, A. bahia, and the estuarine amphipod Leptocheirus plumulosus. No significant mortality to any species via sediment or food matrices was observed at concentrations up to 100 ppm. A novel near-infrared fluorescence spectroscopic method was utilized to measure and characterize the body burdens of pristine SWNTs in nondepurated and depurated organisms. We did not detect SWNTs in depurated organisms but quantified them in nondepurated A. abdita fed SWNT-amended algae. After a 28-d exposure to [(14) C]SWNT-amended sediment (100 µg/g) and algae (100 µg/g), [(14) C]SWNT was detected in depurated and nondepurated L. plumulosus amphipods at 0.50 µg/g and 5.38 µg/g, respectively. The results indicate that SWNTs are bioaccessible to marine benthic organisms but do not appear to accumulate or cause toxicity.

Contaminants enter marine and estuarine environments and pose a risk to human and ecological health. Recently, passive sampling devices have been utilized to estimate dissolved concentrations of COCs, such as polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs). In the present study, the performance of three common passive samplers was evaluated for sampling PAHs and PCBs at several stations in the temperate estuary Narragansett Bay (Rhode Island, USA). Sampler polymers included polyethylene (PE), polydimethylsiloxane (PDMS) coated solid phase microextraction (SPME) fibers, and polyoxymethylene (POM). Dissolved concentrations of each contaminant were calculated using measured sampler concentrations adjusted for equilibrium conditions with performance reference compounds (PRCs) and chemical-specific partition coefficients derived in the laboratory. Despite differences in PE and POM sampler concentrations, calculated total dissolved concentrations ranged from 14–93 ng/L and 13–465 pg/L for PAHs and PCBs, respectively. Dissolved concentrations of PAHs were approximately three times greater based on POM compared to PE while dissolved concentrations of PCBs based on PE were approximately three times greater than POM. Concentrations in SPME were not reported due to the lack of detectable chemical in the amount of PDMS polymer deployed. Continued research is needed to improve and support PE and POM use for the routine monitoring of COCs. For example, a better understanding of the use of PRCs with POM is critically needed.