The aim of this study was to determine the effect of three active substances, diflufenican, mesosulfuron-methyl and iodosulfuron-methyl-sodium, applied in combination, on soil microbial counts, the structure of soil microbial communities, activity of soil enzymes and their resistance to the tested product, the biochemical indicator of soil fertility, and spring wheat yield. Soil samples with the granulometric composition of sandy loam with pHKCl 7.0 were used in a pot experiment. The herbicide was applied to soil at seven doses: 0.057 (dose recommended by the manufacturer), 1.140, 2.280, 4.560, 9.120, 18.240 and 36.480 mg kg−1 soil DM. Uncontaminated soil served as the control treatment. It was found that a mixture of the tested active substances increased the counts of total oligotrophic bacteria and spore-forming oligotrophic bacteria, organotrophic bacteria and actinomycetes, decreased the counts of Azotobacter and fungi, and modified the structure of soil microbial communities. The highest values of the colony development (CD) index and the ecophysiological (EP) index were observed in fungi and organotrophic bacteria, respectively. The herbicide applied in the recommended dose stimulated the activity of catalase, urease and acid phosphatase, but it had no effect on the activity of dehydrogenases, alkaline phosphatase, arylsulfatase and β-glucosidase. The highest dose of the analyzed substances (36.480 mg kg−1) significantly inhibited the activity of dehydrogenases, acid phosphatase, alkaline phosphatase and arylsulfatase. The values of the biochemical soil fertility indicator (BA21) decreased in response to high doses of the herbicide. Urease was most resistant and dehydrogenases were least resistant to soil contamination with a mixture of diflufenican + mesosulfuron-methyl + iodosulfuron-methyl-sodium. The analyzed herbicide had an adverse influence on spring wheat yield, and doses of 18.240 and 36.480 mg kg−1 led to eventual death of plants.

Next-generation herbicides are relatively safe when used properly, but the recommended rates are relatively low, which can lead to overdosing. This study evaluated the responses of soil-dwelling microorganisms and soil enzymes to contamination with the Boreal 58 WG herbicide. The analyzed product contains active ingredients flufenacet and isoxaflutole. All tests were performed under laboratory conditions. The analyzed material was sandy clay. Boreal 58 WG was introduced to soil in four doses. Soil without the addition of the herbicide served as the control. The soil was mixed with the tested herbicide, and its moisture content was maintained at 50% of capillary water capacity. Biochemical and microbiological analyses were performed on experimental days 0, 20, 40, 80 and 160. Accidental contamination of soil with the Boreal 58 WG herbicide led to a relatively minor imbalance in the soil microbiological and biochemical profile. The herbicide dose influenced dehydrogenase activity in only 0.84%, urease activity in 2.04%, β-glucosidase activity in 8.26%, catalase activity in 12.40%, arylsulfatase activity in 12.54%, acid phosphatase activity in 42.11%, numbers of organotrophic bacteria in 18.29%, actinomyces counts in 1.31% and fungi counts in 6.86%.

No abstract

The sensitivity of soil enzymes to soil contamination with zinc was analyzed. A laboratory experiment was performed on sandy loam at pH 7.0, sampled from arable land at a depth of 0 to 20 cm. Soil samples were passed through a sieve with 2 mm mesh size and contaminated with the following zinc doses: 0, 300, 600, 1200 and 2400 mg Zn 2+ kg-1 soil. Zinc was applied in the form of aqueous solution of ZnCl 2. Soil was mixed thoroughly with zinc, and its moisture content was brought to 50% capillary water capacity. The samples were incubated at 25°C. Beakers with soil samples were weighed once a week to replenish evaporated water. The activity of soil enzymes: dehydrogenases, urease, acid phosphatase, alkaline phosphatase, catalase, arylsulfatase and b-glucosidase, was determined after 15, 30, 60 and 120 days of the experiment. The results were used to calculate soil resistance (RS), ED 20 and ED 50 values. The results of the study indicate that soil enzymes are characterized by varied sensitivity to excessive zinc concentrations, and that the RS index is a reliable measure of enzymatic responses to zinc pollution. The analyzed enzymes were classified in the following decreasing order in terms of their resistance to zinc: b-glu-cosidase> acid phosphatase > urease >arylsulfatase = alkaline phosphatase> catalase > dehydrogenases. Zinc continued to exert a negative effect on soil enzymes throughout the experiment (120 days). ED 20 values for the analyzed enzymes in mg Zn 2+ kg-1 DM soil were determined at: 103 for dehydrogenases, 184 for alkaline phosphatase, 233 for urease, 247 for arylsulfatase, 416 for acid phosphatase, 419 for catalase and 1373 for b-glucosidase.

The research objective has been to evaluate the effect, unexplored yet, of a mixture of three active ingredients of the herbicide Lumax 537.5 SE: terbuthylazine (T), mesotrione (M), and S-metolachlor (S) on counts of soil microorganisms, structure of microbial communities, activity of soil enzymes as well as the growth and development of maize. The research was based on a pot experiment established on sandy soil with pHKCl 7.0. The herbicide was applied to soil once, in the form of liquid emulsion dosed as follows: 0.67, 13.4, 26.9, 53.8, 108, 215, and 430 mg kg−1 of soil, converted per active substance (M + T + S). The control sample consisted of soil untreated with herbicide. The results showed that the mixture of the above active substances caused changes in values of the colony development (CD) indices of organotrophic bacteria, actinomycetes, and fungi and ecophysiological diversity (EP) indices of fungi. Changes in the ecophysiological diversity index of organotrophic bacteria and actinomycetes were small. The M + T + S mixture was a strong inhibitor of dehydrogenases, to a less degree catalase, urease, β-glucosidase, and arylsulfatase, while being a weak inhibitor of phosphatases. The actual impact was correlated with the dosage. The M + T + S mixture inhibited the growth and development of maize. The herbicide Lumax 537.5 SE should be applied strictly in line with the regime that defines its optimum dosage. Should its application adhere to the manufacturer’s instructions, the herbicide would not cause any serious disturbance in soil homeostasis. However, its excessive quantities (from 13.442 to 430.144 mg kg−1 DM of soil) proved to be harmful to the soil environment.