Emerging research on printed and flexible graphene-based electronics is beginning to show tremendous promise for a wide variety of fields including wearable sensors and thin film transistors. However, post-print annealing/reduction processes that are necessary to increase the electrical conductivity of the printed graphene degrade sensitive substrates (e.g., paper) and are whole substrate processes that are unable to selectively anneal/reduce only the printed graphene-leaving sensitive device components exposed to damaging heat or chemicals. Herein a pulsed laser process is introduced that can selectively irradiate inkjet printed reduced graphene oxide (RGO) and subsequently improve the electrical conductivity (Rsheet∼0.7 kΩ□(-1)) of printed graphene above previously published reports. Furthermore, the laser process is capable of developing 3D petal-like graphene nanostructures from 2D planar printed graphene. These visible morphological changes display favorable electrochemical sensing characteristics-ferricyanide cyclic voltammetry with a redox peak separation (ΔEp) ≈ 0.7 V as well as hydrogen peroxide (H2O2) amperometry with a sensitivity of 3.32 μA mM(-1) and a response time of <5 s. Thus this work paves the way for not only paper-based electronics with graphene circuits, it enables the creation of low-cost and disposable graphene-based electrochemical electrodes for myriad applications including sensors, biosensors, fuel cells, and theranostic devices.

Optoelectronic performance of metal nanowire networks are dominated by junction microstructure and network configuration. Although metal nanowire printings, such as silver nanowires (AgNWs) or AgNWs/semiconductor oxide bilayer, have great potential to replace traditional ITO, efficient and selective nanoscale integration of nanowires is still challenging owing to high cross nanowire junction resistance. Herein, pulsed laser irradiation under controlled conditions is used to generate local crystalline nanojoining of AgNWs without affecting other regions of the network, resulting in significantly improved optoelectronic performance. The method, laser-induced plasmonic welding (LPW), can be applied to roll-to-roll printed AgNWs percolating networks on PET substrate. First principle simulations and experimental characterizations reveal the mechanism of crystalline nanojoining originated from thermal activated isolated metal atom flow over nanowire junctions. Molecular dynamic simulation results show an angle-dependent recrystallization process during LPW. The excellent optoelectronic performance of AgNW/PET has achieved Rs ∼ 5 Ω/sq at high transparency (91% @λ = 550 nm).

Single-layer graphene (SLG) has been proposed as the thinnest protective/barrier layer for wide applications involving resistance to oxidation, corrosion, atomic/molecular diffusion, electromagnetic interference, and bacterial contamination. Functional metallic nanostructures have lower thermal stability than their bulk forms and are therefore susceptible to high energy photons. Here, we demonstrate that SLG can shield metallic nanostructures from intense laser radiation that would otherwise ablate them. By irradiation via a UV laser beam with nanosecond pulse width and a range of laser intensities (in millions of watt per cm(2)) onto a silver nanowire network, and conformally wrapping SLG on top of the nanowire network, we demonstrate that graphene "extracts and spreads" most of the thermal energy away from nanowire, thereby keeping it damage-free. Without graphene wrapping, the radiation would fragment the wires into smaller pieces and even decompose them into droplets. A systematic molecular dynamics simulation confirms the mechanism of SLG shielding. Consequently, particular damage-free and ablation-free laser-based nanomanufacturing of hybrid nanostructures might be sparked off by application of SLG on functional surfaces and nanofeatures.

No abstract