No abstract

More than 2 million houses in Australia have installed solar photovoltaic (PV) systems; however, apartment buildings have adopted a low percentage of solar PV and battery storage installations. Given that grid usage reduction through PV and battery storage is a primary objective in most residential buildings, apartments have not yet fully benefited from installations of such systems. This research presents shared microgrid configurations for three apartment buildings with PV and battery storage and evaluates the reduction in grid electricity usage by analyzing self-sufficiency. The results reveal that the three studied sites at White Gum Valley achieved an overall self-sufficiency of more than 60%. Owing to the infancy of the shared solar and battery storage market for apartment complexes and lack of available data, this study fills the research gap by presenting preliminary quantitative findings from implementation in apartment buildings.

Common property (CP) is a significant consumer of electricity in apartment buildings. Although some apartments in Australia have adopted shared microgrid configurations to offset grid consumption, the characteristics and load patterns of CP are rarely discussed due to lack of available data. As common areas normally constitute part of owner corporations, energy distribution in these premises requires attention. This paper presents empirical analysis of the CP load connected to shared solar and battery storage for three apartment complexes located in Perth Australia. Load patterns for CP over a defined dataset period were analyzed, and grid usage reduction was examined by implementing and comparing three energy allocation strategies based on surplus energy utilization. The findings indicated significant grid usage reduction for CP load in different apartments after implementation of three strategies. Instantaneous consumption decreased 72%, and surplus allocation strategy reduced 91%, while consumption-based allocation reduced 76%, of grid electricity. Moreover, consumption-based allocation offered improved cost benefits compared to the other two strategies. The results further revealed the usefulness of energy allocation and effectiveness of surplus energy utilization. Based on outcomes, the strategies provide consolidation with conventional energy trading mechanisms and broadly link to the virtual power plant concept for coordinating energy flows between multiple generators.

As the population of urban areas continues to grow, and construction of multi-unit developments surges in response, building energy use demand has increased accordingly and solutions are needed to offset electricity used from the grid. Renewable energy systems in the form of microgrids, and grid-connected solar PV-storage are considered primary solutions for powering residential developments. The primary objectives for commissioning such systems include significant electricity cost reductions and carbon emissions abatement. Despite the proliferation of renewables, the uptake of solar and battery storage systems in communities and multi-residential buildings are less researched in the literature, and many uncertainties remain in terms of providing an optimal solution. This literature review uses the rapid review technique, an industry and societal issue-based version of the systematic literature review, to identify the case for microgrids for multi-residential buildings and communities. The study describes the rapid review methodology in detail and discusses and examines the configurations and methodologies for microgrids.

When considering issues such as power shortage, environmental pollution, and dependence on petroleum, a battery energy storage system (ESS) is one of the promising options to overcome these problems. This paper deals with a 3 kW residential battery ESS that consists of a buck/boost power conversion unit, a DC/AC bidirectional conversion unit, and a Li-ion battery pack with a battery management system. In order to connect an ESS to the grid, the system needs to meet requirements such as having a bidirectional power flow, low THD, and anti-islanding. This paper presents an operation scheme and the implementation of a residential ESS. The scheme was experimentally verified on a prototype.