This paper presents an experimental investigation carried out to study the effects of Ground Granulated Blast Furnace Slag (GGBFS) on strength development of mortar and the optimum use of slag in mortar. Cement was partially replaced with seven percentages (10%, 20%, 30%, 40%, 50%, 60% and 70%) of slag by weight. Ordinary Portland cement (OPC) mortar was also prepared as reference mortar. A total of 400 cube and briquet mortar specimens were cast and compressive as well as tensile strength of the mortar specimens were determined at curing age of 3, 7, 14, 28, 60, 90 and 180 days. Test results show that strength increases with the increase of slag up to an optimum value, beyond which, strength values start decreasing with further addition of slag. Among the seven slag mortars, the optimum amount of cement replacement is about 40%, which provides 19% higher compressive strength and 25% higher tensile strength as compared to OPC mortar. KEY WORDS: Slag; Cement; Mortar; Compressive Strength; Tensile Strength; Hydration. DOI: http://dx.doi.org/10.3329/mist.v3i0.8053
The most commonly used building material in the construction industry is concrete. However, the weak features of concrete are its low ductility and limited tension capacity and hence crack development with the increase in load. These cracks get more worsened by the intrusion of water and salt present in the composition and hence causing deterioration and reducing the longevity of the material. This study focuses on an innovative approach to mitigate concrete’s fractures and flaws by utilizing microbiologically induced calcite (CaCO3) precipitation (MICP) excited by Escherichia coli (E. coli) bacteria to improve the performance of cementitious building materials. The study investigated the development of microbiological concrete in plain water using only one culture density (OD600 0.5 ± 0.1). In this study, two water-to-bacterial mix ratios (75 : 25 and 50 : 50) were used and compared to the conventional concrete (100 : 0). 100-mm cube-sized specimens cured for a period of 7, 28, 90, and 365 days were tested for compressive strength, water absorption capacity, ultrasonic pulse velocity (UPV), and SEM analysis, which were performed on the samples at regular intervals. According to the results of these experiments, microbial concrete with the 50 : 50 ratio exhibited the highest strength for all curing times. From the water absorption test of samples, it is found that the absorption of the materials got reduced due to the infusion of microorganisms in concrete. On the other hand, the UPV test showed high velocity than the control samples for specimens with an OD600 0.5 ± 0.1. Scanning electron microscope (SEM) analysis performed on distinct concrete groups at the age of 28 days showed fewer voids in the concrete lumps due to the increase in water substitution rate caused by microbial culture.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.