Objective: An essential component for optimizing quality of life in adults with cancer is determining the degree to which therapy may negatively impact motor-performance, so that patients can maintain their quality of life and independence. This study examined whether instrumented gait and balance could determine the magnitude of deterioration in motor-performance from chemotherapy-induced peripheral neuropathy (CIPN). Methods: We recruited 84 adults with cancer (age = 71.1 ± 9.7 years old, BMI = 26.8 ± 6.2 kg/m 2 , gender = 56%female) and 57 age-matched non-cancer patients (age = 69.5 ± 9.8 years old, BMI = 27.1 ± 6.0 kg/m 2 , gender = 79%female). Based on clinical screening, the group with cancer was classified into two groups: participants with CIPN (CIPN+) and without CIPN (CIPN-). Gait and balance were quantified using validated wearables. The Vibration Perception Threshold (VPT) test was used to stratify the CIPN+ group into mild (Mild-CIPN) and severe (Severe-CIPN) subgroups. Results: All gait and balance parameters were deteriorated in the group with cancer compared to noncancer group with the largest effects observed for stride-time (11%, Cohen's effect size d = 1.00, p < 0.001) and eyes-closed ankle sway (94%, d = 0.49, p = 0.001). The same trend was observed when the Severe-CIPN subgroup was compared to the Mild-CIPN. VPT correlates significantly with motor deterioration, with the largest correlation found in stride-time (Rho = 0.37, p = 0.007). Severe-CIPN subjects were significantly older and overall had more deterioration in the majority of motor-performance parameters after adjusting for age (p < 0.050). Conclusion: These results confirmed the negative impact of CIPN on motor-performance with the largest effects on ankle stability and stride-time. VPT is a predictor of motor deterioration and may be used to determine the severity of CIPN symptom.

Objective: People with diabetic peripheral neuropathy (DPN) have impaired gait and balance performance. The aim of this study is to investigate therapeutic effectiveness of mechanical stimulation through a wearable foot compression device equipped in a shoe insole on vibration perception, balance control and gait performance in people with DPN. Methods: Using a single-arm 4-week intervention study design, we examined effectiveness of daily use of shoes equipped with the foot compression device (Footbeat™, AVEX, Grand Junction, CO, USA) on improving vibration perception threshold (VPTmax), skin perfusion pressure (SPP), ankle brachial index (ABI), lower extremities edema (circumferences in the calf and ankle), and motor performance (postural sway with eyes open and closed conditions, and gait performance during normal, dual-task and fast walking). Thirty people with type 2 diabetes and symptoms of PN completed the experimental protocol. Results: Improvements in VPTmax (before = 27.4 V, after = 23.3 V, P = .007, d = 0.33, where d denotes effect size), center-of-mass sway in the mediolateral direction with both eyes open and closed conditions (before = 0.94 cm, after = 0.76 cm, P = .020, d = 0.47; before = 1.10 cm, after = 0.83 cm, P = .033, d = 0.66, respectively), and stride velocity for normal walking, dual-task walking and fast walking tasks (before = 0.87 m/s, after = 0.96 m/s, P = .017, d = 0.41; before = 0.75 m/s, after = 0.91 m/s, P = .001, d = 0.77; before = 1.10 m/s, after = 1.20 m/s, P = .043, d = 0.33, respectively) were found post treatment. There was no significant improvement in SPP, ABI, and circumferences in the calf and ankle. Conclusions: Our findings suggest the wearable foot compression device may be effective for reducing neuropathic symptoms and enhancing motor performances in people with DPN.

Please cite this article as: Jamshidinia, M., Atabaki, M.M., Zahiri, M., Kelly, S., Sadek, A., Kovacevic, R.,Microstructural Modification of Ti-6Al-4V by Using an In-Situ Printed Heat Sink in Electron Abstract Unidirectional heat transfer during additive manufacturing (AM) processes results in anisotropy of microstructure and mechanical properties in fabricated components. In the present study, the influence of in-situ printed heat sinks on the microstructure of Ti-6Al-4V was investigated. Different numbers of heat sinks were designed and produced by the Electron Beam Melting® (EBM) process. The coupons were characterized by an optical microscope, scanning electron microscope, tensile and hardness tests, and fracture analysis. An increase in the number of heat sinks was accompanied by a reduction in grain thickness. While elongated grains still formed in all coupons, due to the dominant heat transfer along the buildup direction. The refinement of microstructure was confirmed by a reduction in the average thickness of α-lath from 1.73 μm in the coupon with no heat sink to 1.01 μm in the coupon with the highest number of the heat sinks. The ultimate tensile strength and hardness were increased by increasing the number of heat sinks. The results of fractorgraphy suggested that coupons with the maximum number of heat sinks (5-HS) showed a more ductile fracture. Also, digital reconstruction of the fracture surface showed that the unmelted powder particles had an influence on the crack initiation.

This article presents a hardware/software simulation environment suitable for anytime/anywhere surgical skills training. It blends the advantages of physical hardware and task analogs with the flexibility of virtual environments. This is further enhanced by a web-based implementation of training feedback accessible to both trainees and trainers. Our training system provides a self-paced and interactive means to attain proficiency in basic tasks that could potentially be applied across a spectrum of trainees from first responder field medical personnel to physicians. This results in a powerful training tool for surgical skills acquisition relevant to helping injured warfighters.

Graphical abstract

The absence of significant difference between task performance with/without time feedback shows that using visual real-time feedback can be included in surgical training based on user preference. Trainees may benefit from this type of feedback in the form of increased motivation. The extent to which this can influence training frequency leading to performance improvement is a question for further study.

No abstract

Background: Survivors of childhood cancer (CCS) are at risk for early aging and frailty. Frailty in CCS has been assessed with established clinical criteria, a time-intensive approach requiring specialized training. There is an unmet need for cost-effective, rapid methods for assessing frailty in at-risk adolescent and young adult (AYA) CCS, which are scalable to large populations. Objectives: To validate a sensor-based frailty assessment tool in AYA CCS, compare frailty status between CCS and controls, and assess the correlation between frailty and number of CCS comorbidities. Design, Setting, and Participants: Mean frailty index (MFI) was assessed by a frailty wrist sensor in 32 AYA CCS who were ≥1 year off therapy and in remission. Results were compared with 32 AYA controls without cancer or chronic disease. Measurements: Frailty assessments with and without a simultaneous cognitive task were performed to obtain MFI. Results were compared between cases and controls using a Student t test, and the number of pre-frail/frail subjects by Chi Square test. The contribution of radiation therapy (RT) exposure to MFI was assessed in a sub-analysis, and the correlation between the number of comorbidities and MFI was measured using the Pearson method. Results: MFI was strongly correlated with gait speed in AYA CCS. CCS were more likely to be pre-frail than controls without cancer history (p=0.032), and CCS treated with RT were more likely to be pre-frail than CCS not treated with RT (p<0.001). The number of comorbidities was strongly correlated with MFI (ρ=0.65), with a 0.028 increase in MFI for each added condition (p<0.001). Conclusions: Results from this study support higher risk for frailty among CCS, especially those with multiple comorbidities or who were treated with RT. A wrist-worn sensor-based method is feasible for application in AYA CCS, and provides an opportunity for cost-effective, rapid screening of at-risk AYA CCS who may benefit from early interventions.