The emissive properties of two Ru­(II) complexes, [Ru­(dmbipy)2L1]­[PF6]2 (1) and [Ru2(dmbipy)4L2]­[PF6]4 (2), (where L1 and L2 are π-extended phenanthroline-based ligands and dmbipy = 4,4′-dimethyl-2,2′-bipyridine) have been explored for dual applications, namely, deep-red light-emitting electrochemical cells (LECs) and electrochemiluminescence (ECL) sensors for the detection of organophosphorus pesticides (OPs) that include chlorpyrifos (CPS). A simple single-layer deep-red LEC device comprising 2 is reported that outperforms both its mononuclear derivative 1 and all previously reported dinuclear LECs, with a maximum brightness of 524 cd/m2, an external quantum efficiency of 0.62%, and a turn-on voltage of 3.2 V. Optoelectronic studies reveal that the ECL response of 2 is improved when compared to its mononuclear counterpart 1 and benchmark [Ru­(bipy)3]2+ (3). Modified glassy carbon electrodes coated with 2 are highly sensitive deep-red ECL sensors that facilitate the detection of CPS directly from river water and fruit samples without any complex pretreatment steps, operating over a broad logarithmic concentration range, with a low detection limit.

In this work, a novel electrochemiluminescent (ECL) pesticide sensor based on zinc oxide nanocrystals decorated nickel foam is proposed for determination of imidacloprid for the first time. The silica film was used as a morphology‐controlling factor for modification of the electrode with zinc oxide nanocrystals. Zinc oxide was selected as luminescent material due to its cheapness, non‐toxicity, high thermal stability and excellent luminescence properties which truly adhered on the surface of nickel foam. The K2S2O8 was used as strong co‐reactant for this purpose. The silica template plays an important role in controlling the size of ZnO nanocrystals. The Physical morphology of the ZnO/Ni‐foam electrode was performed by electrochemical impedance spectroscopy, Brunauer‐Emmett‐Teller (BET), X‐Ray diffraction analysis, field emission scanning electron microscopy, and energy‐dispersive X‐ray analysis. The ultra‐sensitive electrochemiluminescence method was successfully used for ultra‐trace determination of imidacloprid. The linear dynamic range and low detection limit were obtained 3×10−14 −8×10−8 M and 4.4×10−15 M, respectively. Also, the relative standard deviation for 15 repetitive optical signals was calculated 1.09 %.The present ECL sensor exhibited superior performance toward the accurate determination of imidacloprid with good reproducibility and stability.

No abstract

In this project, Pt/NiO−GO nanocatalyst is grown on nickel foam (NF) and, its catalytic activity towards electrochemical oxidation of methanol in acidic media is studied. The first step is devoted to the synthesis of NiO−GO support by a hydrothermal method. Then Pt nanoparticles (∼34.3 nm) are electrodeposited on this supporting material. Hydrothermal and electrochemical deposition conditions are optimized. Surface of modified NF was inspected for physical characterization and Chemical composition by some techniques such as field emission scanning electron microscopy (FESEM), energy‐dispersive X‐ray spectra (EDS), and X‐ray diffraction (XRD). In the electrochemical section, the catalytic performance of Pt/NiO−GO/NF towards methanol oxidation is investigated by cyclic voltammetry and chronoamperometry measurements. The electrochemical impedance spectroscopy (EIS) is elected to deliberate charge transfer resistance on the catalyst surface. Mass activity, electrochemical surface area (ECSA) and durability of prepared catalysts are compared with commercial Pt/C. Deliberations prove the superiority of Pt/NiO−GO/NF towards methanol oxidation in acidic media. The Superior quality of synthesized nanocatalyst that is attributed to the synergetic effect of the NiO−GO support material and Pt nanoparticles, indicate that Pt/NiO−GO/NF can be successfully used as the anode in the direct methanol fuel cell (DMFC).

No abstract