In this paper, we report an efficient numerical method to predict fluid flow behavior in a square and deep lid-driven cavities. The conventional continuity and momentum equations are transformed into stream-function and vorticity formulation to reduce the number of unknown spatial quantities. Numerical experiments were performed with different values of aspect ratio and Reynolds number to investigate the effect of these dimensionless parameters on the fluid flow behavior in the cavity. In the current study, we found that the dynamics and the structure of primary vortex are significantly affected by the Reynolds number and the aspect ratio of the cavity.
Liquid sloshing is any motion of free liquid surface inside its container. Sloshing may generate hydrodynamics loads that can be dangerous to structural integrity and stability of moving container. In this study, liquid sloshing in cubical and cylindrical containers with similar characteristic length were investigated. The containers with liquid inside were excited sinusoidally by using an electrodynamics shaker while the free liquid surface level change was captured by using high speed camera. The highest free liquid surface level difference obtained for cylindrical and cubical containers were compared. Results show that cylindrical containers produce less liquid sloshing and thus more suitable to be used for liquid transportation.
The awareness to produce biodegradable composite has increased rapidly because of non-toxic and reachable. However, fully biodegradable composite production still low due to the matrix used in the composite is not biodegradable. Thus, this paper presents the study on mechanical and physical properties for the mixtures of corn starch (CS) with different weight percentages of glycerol as thermoplastics corn starch (TPCS) matrix. The selected glycerol contents were at 30, 35 and 40 wt%. The mixtures of CS and different weight percentages of glycerol were made using hot compression moulding at 165°C for 15 minutes to produce the TPCS samples. The mechanical and physical properties were done: the tensile test, hardness test, water absorption test, moisture content test and microstructure analysis under the Scanning Electron Microscopes (SEM). Incorporating 30 wt% loadings of glycerol has increased the tensile strength and hardness. The results show that the addition of higher than 30 wt% loadings of glycerol has decreased the tensile strength and hardness of the TPCS. The physical test results for 30 wt% loadings of glycerol for water absorption test and moisture content show the lowest value than other TPCS samples. However, the density value for all wt% loadings of glycerol does not offer much difference. It reveals that 30 wt% loadings of glycerol in the mixture of CS have shown a good interaction in the TPCS mechanical properties. Based on this finding, the TPCS has huge potential to be used as a matrix to develop a fully biodegradable composite.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.