This paper presents an experimental and modeling study of the oxidation of large linear akanes (from C 10 ) representative from diesel fuel from low to intermediate temperature (550-1100 K) including the negative temperature coefficient (NTC) zone. The experimental study has been performed in a jet-stirred reactor at atmospheric pressure for n-decane and a n-decane/n-hexadecane blend. Detailed kinetic mechanisms have been developed using computer-aided generation (EXGAS) with improved rules for writing reactions of primary products. These mechanisms have allowed a correct simulation of the experimental results obtained. Data from the literature for the oxidation of n-decane, in a jet-stirred reactor at 10 bar and in shock tubes, and of n-dodecane in a pressurized flow reactor have also been correctly modeled. A considerable improvement of the prediction of the formation of products is obtained compared to our previous models. Flow rates and sensitivity analyses have been performed in 1 * E-Mail : Frederique.Battin-Leclerc@ensic.inpl-nancy.fr, Tel : 33 3 83175125, Fax : 33 3 83378120 order to better understand the influence of reactions of primary products. A modeling comparison between linear alkanes for C 8 to C 16 in terms of ignition delay times and the formation of light products is also discussed.

This paper describes an experimental and modeling study of the oxidation of methyl and ethyl butanoates in a shock tube. The ignition delays of these two esters mixed with oxygen and argon for equivalence ratios from 0.25 to 2 and ester concentrations of 0.5% and 1% were measured behind a reflected shock wave for temperatures from 1250 to 2000 K and pressures around 8 atm. To extend the range of studied temperatures in the case of methyl butanoate, two sets of measurements were also made in a jet-stirred reactor at 800 and 850 K, at atmospheric pressure, at residence times varying between 1.5 and 9 s and for equivalence ratios of 0.5 and 1. Detailed mechanisms for the combustion of methyl and ethyl butanoates have been automatically generated using a version of EXGAS software improved to take into account these oxygenated reactants. These mechanisms have been validated through comparison of simulated and experimental results in both types of reactor. The main reaction pathways have been derived from reaction flux and sensitivity analyses performed at different temperatures.

a b s t r a c tThe experimental study of the oxidation of two blend surrogates for diesel and biodiesel fuels, n-decane/ n-hexadecane and n-decane/methyl palmitate (74/26 mol/mol), has been performed in a jet-stirred reactor over a wide range of temperatures covering both low, and high-temperature regions (550-1100 K), at a residence time of 1.5 s, at quasi atmospheric pressure with high dilution in helium (hydrocarbon inlet mole fraction of 0.002) and at stoichiometric conditions. Numerous reaction products have been identified and quantified. At low and intermediate temperatures (less than 1000 K), the formation of oxygenated species such as cyclic ethers, aldehydes and ketones has been observed for n-decane, n-hexadecane, and methyl palmitate. At higher temperature, the formation of these species was not observed any more, and small amounts of unsaturated species (olefins and unsaturated methyl esters) have been detected.Results obtained with methyl palmitate and n-hexadecane have been compared in order to highlight similarities and differences between large n-alkanes and methyl esters.