No abstract

No abstract

Magmatic rocks represent one of the most significant rocks due to their abundance, durability and appearance; they can be used as ornamental stones in the construction of dwellings. The current study is concerned with the detailed petrography and natural radioactivity of seven magmatic rocks. All are commercial granitic rocks and are identified as black Aswan, Nero Aswan, white Halayeb, Karnak, Verdi, red Hurghada and red Aswan. Their respective mineralogical compositions are classified as porpheritic granodiorite, granodiorite, tonalite, monzogranite, syenogranite, monzogranite and syenogranite. A total of nineteen samples were prepared from these seven rock types in order to assess their suitability as ornamental stones. Concentrations of 226Ra, 232Th and 40K radionuclides were measured using NaI (Tl) scintillation gamma-ray spectrometry. Among the studied magmatic rocks, white Halayeb had the lowest average values of 226Ra (15.7 Bq/kg), 232Th (4.71 Bq/kg) and 40K (~292 Bq/kg), all below the UNSCEAR reported average world values or recommended reference limits. In contrast, the other granitic rocks have higher values than the recommended limit. Except for the absorbed dose rate, other radiological hazard parameters including radium equivalent activity, annual effective dose equivalent, external, and internal hazard indices reflect that the White Halyeb rocks are favorable for use as ornamental stone in the construction of luxurious and high-demand residential buildings.

The aim of the present study is to link the thermal expansion, spectral reflectance, and physico-mechanical aspects of different types of commercial granitic rocks with their mineralogical and chemical composition. The granitic rock types were characterized using several analyses, including petrography, chemical, mineralogical, and thermo-gravimetrical analysis using XRF, XRD, and TG/DTG/DSC techniques. The rock types were subjected to several performance tests, such as tests of their thermal expansion, spectral reflectance, and physico-mechanical properties. The results revealed that quartz, albite, and potash feldspar with minor amounts of mica (biotite/muscovite/annite) are the main mineralogical constitutes, in addition to some alteration minerals, such as kaolinite, saussorite, and prehnite. The studied granitic rocks were classified as monzogranite/syenogranite of high K-calc-alkaline and peraluminous characters and are related to late- to post-collisional settings. The thermogravimetrical analysis revealed that the overall mass loss over the whole temperature range up to 978 °C did not exceed 3% of the initial weight for all studied rocks. The results of thermal expansion revealed that the maximum change in linear thermal expansion for all rock types did not exceed 0.015% of their initial lengths at an unusual air temperature of 50 °C. The spectral analysis revealed that iron and hydroxyl ions are the main spectral absorption features that appeared in the VIS-NIR and SWIR regions, in addition to the appearance of the common and distinctive absorption peaks of the main mineral composition. Furthermore, the spectral reflectance demonstrated that the granitic rock types of low iron oxide content achieved a high reflectivity percent in the VIS-NIR and SWIR spectral regions compared with those of high iron content. As a general trend, the granitic rock types of high iron content and/or lower quartz content exhibited a high performance regarding their physical and mechanical properties, such as water absorption, apparent porosity, bulk density, compressive strength, and abrasion resistance. The results of water absorption, density, strength, and abrasion resistance of the studied granitic rocks are in the range of 0.14–0.31%, 2582–2644 kg/m3, 77.85–222.75 MPa, and 26.27–55.91 Ha, respectively, conforming to the requirements of ornamental stones according to the ASTM standard.

No abstract