A communication system is proposed for the Internet of Things (IoT) applications in desert areas with extended coverage of regional area network requirements. The system implements a developed six-element array that operates at a 2.45 GHz frequency band and is optimized to reduce the size and limit element coupling to less than −20 dB. Analysis of the proposed system involves a multiple-input multiple-output (MIMO) operation to obtain the diversity gain and spectral efficiency. In addition, the radiation efficiency of the proposed antenna is greater than 65% in the operation bandwidth (more than 30 MHz) with a peak of 73% at 2.45 GHz. Moreover, an adaptive beamforming system is presented based on monitoring the direction of arrival (DOA) of various signals using the root MUSIC algorithm and utilizing the DOA data in a minimum variance distortionless response (MVDR) technique beamformer. The developed array is found to have an envelope correlation coefficient (ECC) value of less than 0.013, mean effective gain (MEG) of more than 1 dB, diversity gain of more than 9.9 dB, and channel capacity loss (CCL) of less than 0.4 bits/s/Hz over the operation bandwidth. Adaptive beamforming is used to suppress interference and enhance the signal-to-interference noise ratio (SINR) and is found to achieve a data rate of more than 50 kbps for a coverage distance of up to 100 km with limited power signals.

No abstract

This paper addresses the design of a hybrid beamforming system considering the circuit parameter of six-bit millimeter-wave phase shifters based on the process design kit. The phase shifter design adopts 45 nm CMOS silicon on insulator (SOI) technology at 28-GHz. Various circuit topologies are utilized, and in particular, a design is presented based on switched LC components, connected in a cascode manner. The phase shifter configuration is connected in a cascading manner to get the 6-bit phase controls. Six different phase shifters are obtained, which are 180°, 90°, 45°, 22.5°, 11.25°, and 5.6°, with a minimum number of LC components. The circuit parameters of the designed phase shifters are then incorporated in a simulation model of hybrid beamforming for a multiuser MIMO system. The number of OFDM data symbols used in the simulation is ten for eight users, 16 QAM modulation schemes, −25 dB SNR, 120 simulation runs, and around 170 h runtime. Simulation results are obtained considering four and eight users, assuming accurate technology-based models of RFIC components of the phase shifter as well as ideal phase shifter parameters. The results indicate that the performance of the multiuser MIMO system is affected by the accuracy level of the phase shifter RF component models. The outcomes also reveal the performance tradeoff based on user data streams and the number of BS antennas. By optimizing the amount of parallel data streams per user, higher data transmission rates are achieved, while maintaining acceptable error vector magnitude (EVM) values. In addition, stochastic analysis is conducted to investigate the distribution of the RMS EVM. The outcomes show that the best fitting of RMS EVM distribution of the actual and ideal phase shifters agreed with the log-logistic and logistic distributions, respectively. The obtained (mean, variance) values of the actual phase shifters based on accurate library models are (46.997, 481.36), and for ideal components the values are (36.47, 10.44).