No abstract

Liver status, resection of caudate lobe, lymph node status, R0 resection and CA19-9 were demonstrated to be independent risk factors for long term survival.

Introduction: Laparoscopic pancreaticoduodenectomy (LPD) is a complex and challenging procedure even with experienced surgeons. The aim of this study is to evaluate the feasibility and surgical and oncological outcomes of LPD compared with open pancreaticoduodenectomy (OPD). Patients and Method: This is a propensity score–matched analysis for patients with periampullary tumors who underwent PD. Patients underwent LPD and matched group underwent OPD included in the study. The primary outcome measure was the rate of total postoperative morbidities. Secondary outcomes included operative times, hospital stay, wound length and cosmosis, oncological outcomes, recurrence rate, and survival rate. Results: A total of 111 patients were included in the study (37 LPD and 74 OPD). The conversion rate from LPD to OPD was 4 cases (10.8%). LPD provides significantly shorter hospital stay (7 vs. 10 d; P=0.004), less blood loss (250 vs. 450 mL, P=0.001), less postoperative pain, early oral intake, and better cosmosis. The length of the wound is significantly shorter in LPD. The operative time needed for dissection and reconstruction was significantly longer in LPD group (420 vs. 300 min; P=0.0001). Both groups were comparable as regards lymph node retrieved (15 vs. 14; P=0.21) and R0 rate (86.5% vs. 83.8%; P=0.6). No significant difference was seen as regards postoperative morbidities, re-exploration, readmission, recurrence, and survival rate. Conclusions: LPD is a feasible procedure; it provided a shorter hospital stay, less blood loss, earlier oral intake, and better cosmosis than OPD. It had the same postoperative complications and oncological outcomes as OPD.

Background: Laparoscopic Heller cardiomyotomy (LHM) with Dor fundoplication represents the most commonly accepted surgical management for achalasia. The ideal extent of myotomy on the gastric side remains a matter of continuous debate. The aim of this study was to compare the impact of the extent of myotomy on the gastric side on the outcome of LHM.Patients and Methods: Patients with achalasia who underwent LHM included in the study. The patients were classified according to the length of the gastric myotomy into 3 groups (group I: <1.5 cm, group II: 1.5 to 2.5 cm, and group III: > 2.5 cm).Results: In total, 212 patients (94 males and 118 females) with achalasia treated by LHM and Dor fundoplication included in the study. No statistically significant differences were found among the 3 groups as regards preoperative data, intraoperative mucosal perforation, operative time, blood loss, and hospital stay. The incidence of persistent dysphagia was significantly higher in the group I. Postoperative GERD symptoms were significantly higher in group III (23.3%, P < 0.0001). Recurrent achalasia was significantly higher in group I with 11 patients (15.9%), 8 patients in group II (7.1%), and nil in group III (P < 0.02).Conclusions: Longer myotomy on the gastric side ( > 2.5 cm) ensures complete division of the LES with better outcomes in term of resolution of dysphagia but may be associated with higher postoperative GERD. Therefore, a myotomy length of 1.5 to 2.5 cm on the gastric side provides a balance between relieve of dysphagia and development of postoperative GERD.

Fiber reinforced polymerThe main objective of this study submit bases for the local textile uses in different scope in structural engineering and knowing the maximum load of the standard concrete element after adhesion to composed FRP with epoxy, and Put the scientific and the best style to use the FRP and its affecting on increasing the structural capacity for the various structural elements with consideration for cost and price. Reinforced concrete (RC) slabs can be divided into two main groups, namely beamless and beam supported slabs. Beamless slabs (flat slabs) are among the first types of reinforced concrete floor systems. Flat slabs have been used in different structural applications, such as floors and roofs of buildings, parking garages, walls of tanks, and offshore structures.