This paper presents an iterative method for calculating the effective contact ratio and the bending tooth stress for a pair of plastic/plastic and plastic/steel spur gears with an involute profile. In this method, the pinion and the gear are modeled, at each moment of the mesh cycle, as equivalent springs in parallel undergoing the same displacement along the line of action. This leads to the calculation of the bending stress by taking into account the number of teeth initially in contact and those which enter in contact prematurely. We also investigate the influence of certain gear parameters, such as, the number of teeth, the pressure angle, and the module on the behavior of a pair of meshed gears. In addition, the variation of the bending stress at the tooth fillet is investigated for a pair of plastic/plastic and a pair of plastic/steel spur gears, in order to determine the critical configurations for which the bending stress is maximum. In general, the results obtained from the present method also show that the stress variation in plastic/plastic gears differs markedly from that in plastic/steel gears.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.