Mechanophores are force-responsive molecules that have the potential to serve as stress sensors in various material systems. This review discusses recent scientific advances and critical challenges facing engineers regarding implementation of mechanophores in polymeric materials.

The ORCID identification number(s) for the author(s) of this article can be found under https://doi.org/10.1002/adem.202101080.

Column buckling mechanics were examined as a technique to determine the modulus of glassy polymer films that fail at very low strains in tension. As an alternative modulus measurement technique, free-standing column buckling (FSCB) mechanics were investigated here. Given the film geometries and the critical buckling load, classical relationships can be used to determine the modulus. Several polymeric materials were tested and compared to uniaxial tensile values to determine the robustness and validity of the technique. Film geometries were varied from 4 to 18 mm in width and from 15 to 60 mm in length. The films were compressed in plane until buckling occurred and the critical buckling load was measured for each geometry. The critical buckling load increased as film width increased and decreased as film length increased, while the thickness was held constant for each material. For polyethylene terephthalate films, the elastic modulus was determined to be 3.06 AE 0.58 GPa. This FSCB-determined modulus was compared to the elastic modulus obtained by tensile testing (3.54 AE 0.2 GPa). The modulus measurement technique presented here has the potential to be used experimentally to determine the elastic modulus of glassy polymer films that perform poorly in tension.

Scratches in polymer coatings and barrier layers negatively impact optical properties (haze, light transmission, etc.), initiate routes of degradation or corrosion (moisture permeability), and nucleate delamination of the coating. Detecting scratches in coatings on advanced materials systems is an important component of structural health monitoring but can be difficult if the defects are too small to be detected by the naked eye. The primary focus of the present work is to investigate scratch damage using fluorescence lifetime imaging microscopy (FLIM) and mechanical activation of a mechanophore (MP)-containing transparent epoxy coating. The approach utilizes a Berkovich tip to scratch MP-epoxy coatings under a linearly increasing normal load. The goal is to utilize the fluorescent behavior of activated MPs to enable the detection of microscale scratches and molecular scale changes in polymeric systems. Taking advantage of the amine functionality present in a polyetheramine/bisphenol A epoxy network, a modified rhodamine dye is covalently bonded into a transparent, thermoset polymer network. Following instrumented scratch application, subsequent fluorescence imaging of the scratched MP-epoxy reveals the extent of fluorescence activation induced by the mechanical deformation. In this work, the rhodamine-based mechanophore is used to identify both ductile and fracture-dominated processes during the scratch application. The fluorescence intensity increases linearly with the applied normal load and is sensitive to fracture dominated processes. Fluorescence lifetime and hyperspectral imaging of damage zones provide additional insight into the local (nanoscopic) environment and molecular structure of the MP around the fracture process zone, respectively. The mechanophore/ scratch deformation approach allows a fluorescence microscope to probe local yielding and fracture events in a powerful way that enhances the optical characterization of damage zones formed by standard scratch test methods and leads to novel defect detection strategies.

No abstract

The use of composite materials has seen many new innovations for a large variety of applications. The area of reinforcement in composites is also rapidly evolving with many new discoveries, including the use of hybrid fibers, sustainable materials, and nanocellulose. In this review, studies on hybrid fiber reinforcement, the use of nanocellulose, the use of nanocellulose in hybrid forms, the use of nanocellulose with other nanomaterials, the applications of these materials, and finally, the challenges and opportunities (including safety issues) of their use are thoroughly discussed. This review will point out new prospects for the composite materials world, enabling the use of nano- and micron-sized materials together and creating value-added products at the industrial scale. Furthermore, the use of hybrid structures consisting of two different nano-materials creates many novel solutions for applications in electronics and sensors.

No abstract

No abstract