The upward movement of water due to transpiration stops when soil water potential ( s ) drops below leaf water potential ( L ). Under these circumstances, water can move in any direction in the plant-soil continuum through the passive conduits of roots and stems towards the lowest  s . This is generally termed as hydraulic redistribution (HR), but the positioning and orientation of the driving water potential gradient may vary. Any experimental method that can measure bi-directional and low flows in the sapwood of roots and stems will be suitable to detect HR. Using one approach for measuring sap flow (the heat field deformation technique, HFD) in several forest species and sites across Europe, we were able to provide evidence on different types of HR: vertical hydraulic redistribution (VHR), horizontal hydraulic redistribution (HHR), foliar uptake (FU) and tissue dehydration (TD). VHR is the vertical water movement through roots in response to water potential differences between deep and topsoil, either hydraulic lift or hydraulic descent. HHR is the lateral water movement through roots in response to horizontal water potential gradients, namely under localised irrigation. FU is the water movement from crown to soil through stems when the crown is wetted by foggy weather. TD is the downward movement of water in stems or roots from above-ground tree tissues to soil under prolonged drought or frost. Results from direct sap flow measurements indicated the vectoral and widespread nature of HR, a phenomenon of paramount importance for overall physiology and ecohydrology.

No abstract

Numerous recent laboratory studies have shown that vegetation can influence soil water flow by inducing very low levels of water repellency. In this study we extended on this previous research by developing a field-based test using a miniature infiltrometer to assess low levels of water repellency from physically based measurements of liquid flow in soil. The field-based test was verified through a simple laboratory experiment and then applied to determine the impact of vegetation and antecedent soil water content. The soil hydraulic properties determined were hydraulic conductivity, sorptivity, as well as the persistence and index of water repellency. Tests were conducted following a dry spell and wet spell on (1) forest soil (0 cm depth), (2) glade soil (0 cm depth) and (3) glade soil (50 cm depth). It was found that both the persistence and index of water repellency, R, decreased in the order as follows: forest soil > glade soil (0 cm) > glade soil (50 cm) for both dry and wet spell. The range of values of R was 0.28 (wettable) to 360 (highly water repellent), which affected hydraulic conductivity kr(-2 cm). R increased and hence kr(-2 cm) decreased in the order: forest soil < glade soil (0 cm) < glade soil (50 cm) for both the dry and wet spell. There were clear interactions between vegetation and changes to water flow caused by presence of repellency.

No abstract

Abstract. Plant transpiration links physiological responses of vegetation to water supply and demand with hydrological, energy, and carbon budgets at the land–atmosphere interface. However, despite being the main land evaporative flux at the global scale, transpiration and its response to environmental drivers are currently not well constrained by observations. Here we introduce the first global compilation of whole-plant transpiration data from sap flow measurements (SAPFLUXNET, https://sapfluxnet.creaf.cat/, last access: 8 June 2021). We harmonized and quality-controlled individual datasets supplied by contributors worldwide in a semi-automatic data workflow implemented in the R programming language. Datasets include sub-daily time series of sap flow and hydrometeorological drivers for one or more growing seasons, as well as metadata on the stand characteristics, plant attributes, and technical details of the measurements. SAPFLUXNET contains 202 globally distributed datasets with sap flow time series for 2714 plants, mostly trees, of 174 species. SAPFLUXNET has a broad bioclimatic coverage, with woodland/shrubland and temperate forest biomes especially well represented (80 % of the datasets). The measurements cover a wide variety of stand structural characteristics and plant sizes. The datasets encompass the period between 1995 and 2018, with 50 % of the datasets being at least 3 years long. Accompanying radiation and vapour pressure deficit data are available for most of the datasets, while on-site soil water content is available for 56 % of the datasets. Many datasets contain data for species that make up 90 % or more of the total stand basal area, allowing the estimation of stand transpiration in diverse ecological settings. SAPFLUXNET adds to existing plant trait datasets, ecosystem flux networks, and remote sensing products to help increase our understanding of plant water use, plant responses to drought, and ecohydrological processes. SAPFLUXNET version 0.1.5 is freely available from the Zenodo repository (https://doi.org/10.5281/zenodo.3971689; Poyatos et al., 2020a). The “sapfluxnetr” R package – designed to access, visualize, and process SAPFLUXNET data – is available from CRAN.

Abstract:Ponded infiltration experiment is a simple test used for in-situ determination of soil hydraulic properties, particularly saturated hydraulic conductivity and sorptivity. It is known that infiltration process in natural soils is strongly affected by presence of macropores, soil layering, initial and experimental conditions etc. As a result, infiltration record encompasses a complex of mutually compensating effects that are difficult to separate from each other. Determination of sorptivity and saturated hydraulic conductivity from such infiltration data is complicated. In the present study we use numerical simulation to examine the impact of selected experimental conditions and soil profile properties on the ponded infiltration experiment results, specifically in terms of the hydraulic conductivity and sorptivity evaluation. The effect of following factors was considered: depth of ponding, ring insertion depth, initial soil water content, presence of preferential pathways, hydraulic conductivity anisotropy, soil layering, surface layer retention capacity and hydraulic conductivity, and presence of soil pipes or stones under the infiltration ring. Results were compared with a large database of infiltration curves measured at the experimental site Liz (Bohemian Forest, Czech Republic). Reasonably good agreement between simulated and observed infiltration curves was achieved by combining several of factors tested. Moreover, the ring insertion effect was recognized as one of the major causes of uncertainty in the determination of soil hydraulic parameters.

Abstract:The interception was recognized as an important part of the catchment water balance in temperate climate. The mountainous forest ecosystem at experimental headwater catchment Liz has been subject of long-term monitoring. Unique dataset in terms of time resolution serves to determine canopy storage capacity and free throughfall. Spatial variability of throughfall was studied using one weighing and five tipping bucket rain gauges. The basic characteristics of forest affecting interception process were determined for the Norway spruce stand at the experimental area -the leaf area index was 5.66 -6.00 m 2 m -2 , the basal area was 55.7 m 2 ha -1 , and the crown closure above individual rain gauges was between 19 and 95%. The total interception loss in both growing seasons analyzed was 34.5%. The mean value of the interception capacity determined was about 2 mm. Throughfall exhibited high variability from place to place and it was strongly affected by character of rainfall. On the other hand, spatial pattern of throughfall in average showed low variability.

The effects of adding 1-3% (weight) kaolinite or Ca-montmorillonite on the we�ability of silica sand, made highly water repellent with stearic acid, was studied during we�ing and prolonged drying phases at 50°C. The persistence of water repellency was estimated with the water drop penetration time (WDPT) test. A�er we�ing water repellency disappeared in all the samples. During the drying phase, water repellency re-appeared in all samples (untreated and clay-treated) as the water content decreased below 1%. Repellency did, however, not reach pre-we�ing levels. The effect of clay additions on water repellency differed strongly between the two clay types. Kaolinite reduced WDPT, while Ca-montmorillonite caused an increase in WDPT in the already highly repellent sand. Potential mechanisms for the alleviation effectiveness of kaolinite are proposed, with key factors being the high adhesion forces between water and clay mineral surfaces, and the ability kaolinite to disperse. In the case of Ca-montmorillonite, its lower affinity for water may lead to a displacement of water molecules at mineral surfaces by amphiphilic organic compounds, which may result in increased repellency. This phenomenon clearly requires further investigation.