In the recent time forest harvesting is mainly related to the use of chainsaws. They are acceptably light, safe, cheap and multifunctional. At the same time, chainsaws can cause personal illnesses considering their vibrations and noise. This article deals with conditions and assessment evaluation of effects on workers caused by vibrations and noise in the case of professional chainsaws in operation. Mechanical vibrations and noise are mainly related to the back-and-forth movement of the piston, and to a lesser extent, to the cutting chain. The experiment revealed, in general, that design parameters have a minimal influence on chainsaw vibration and noise emissions. Specifically, the statistical analysis for frequency weighted vibration showed no difference between types of guide bars, types of saw chains and wood plant in terms of noise and vibration on handles.
The article deals with data in the cutting process of wood-based materials. The cutting process influences the shape and dimensions of a cutting edge. The experiments were focused on monitoring the changes of the cutting edge in machining of particle board and the influence of cutting speed on the tool wear. Cutting tests were performed during milling at cutting rates in the range 7.95 to 17.9 m/s (477 to 1074 m/min), a depth of cut of 9.5 mm, and a tooth feed of 0.05 mm. The wear process of cutting wedge during particle board milling is characterized by a decrease in the cutting edge of insert blades. The comparative digital dial gauge was used for measurement of the cutting wedge recession. The course of the wear of wood based materials exhibited similarity in graphical representation with abrasive material cutting. The resulting dependency may be used for selection of the most suitable cutting conditions according to operator requirements.
Aim of this paper was to investigate the effects of grit size and wood species on mass concentration and size distribution of wood dust produced by hand-held belt sander. Experimental study was designed as 2x2 full factorial experiments. Experimental parameters and their levels were abrasive grain size (P80, P120) and wood species (European beech (Fagus sylvatica L.), Norway spruce (Picea abies)).The mass concentration of emitted wood dust was measured using aerosol monitor (TSI Inc., DustTrak DRX 8533). Sampler head was sited in place representing breathing zone of operator of sander. The results was analysed employing the analysis of variance (ANOVA) with 5% of significance level. Real-time measurements demonstrated that spruce wood generated higher dust concentrations than beech wood due to difference in abrasion durability. Compared to sanding belt with P80 grit size, approximately 16%-32% higher dust concentration was generated when the sanding belt with P120 grit size was used.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.