The optical Stark effect is a coherent light–matter interaction describing the modification of quantum states by non-resonant light illumination in atoms, solids and nanostructures. Researchers have strived to utilize this effect to control exciton states, aiming to realize ultra-high-speed optical switches and modulators. However, most studies have focused on the optical Stark effect of only the lowest exciton state due to lack of energy selectivity, resulting in low degree-of-freedom devices. Here, by applying a linearly polarized laser pulse to few-layer ReS2, where reduced symmetry leads to strong in-plane anisotropy of excitons, we control the optical Stark shift of two energetically separated exciton states. Especially, we selectively tune the Stark effect of an individual state with varying light polarization. This is possible because each state has a completely distinct dependence on light polarization due to different excitonic transition dipole moments. Our finding provides a methodology for energy-selective control of exciton states.
Broadband detection of mid-infrared (IR) photons extends to advanced optoelectronic applications such as imaging, sensing, and telecommunications. While graphene offers an attractive platform for broadband visible/IR photodetection, previous efforts to improve its responsivity, for example, by integrating light-absorbing colloids or waveguide or antenna fabrication, were achieved at the cost of reduced photon detection bandwidth. In this work, we demonstrate room-temperature operation of a novel mid-IR photodetector based on a graphene−Bi 2 Se 3 heterostructure showing broadband detection and high responsivity (1.97 and 8.18 A/W at mid-and near-IR, respectively), in which simultaneous improvement of the spectral range and responsivity is achieved via exploiting broadband absorption of mid-IR and IR photons in a small-band-gap Bi 2 Se 3 topological insulator and efficient hot carrier separation and strong photogating across the Bi 2 Se 3 /graphene interface. With sufficient room for further improvement by interface engineering, our results show a promising route to realize ultrabroadband, high-responsivity hot-carrier optoelectronics at room temperature.
Using a macroscopic ensemble of highly-enriched (6,5) single-wall carbon nanotubes, combined with high signal-to-noise ratio, time-dependent differential transmission spectroscopy, we have generated vibrational modes in an ultrawide spectral range (10-3000 cm −1 ). A total of fourteen modes were clearly resolved and identified, including fundamental modes of A, E1, and E2 symmetries and their combinational modes involving two and three phonons. Through comparison with CW Raman spectra as well as calculations based on an extended tight-binding model, we were able to identify all the observed peaks and determine the frequencies of the individual and combined modes. We provide a full summary of phonon frequencies for (6,5) nanotubes that can serve as a basic reference with which to refine our understanding of nanotube phonon spectra as well as a testbed for new theoretical models.
Coherent light−matter interaction can transiently modulate the quantum states of matter under nonresonant laser excitation. This phenomenon, called the optical Stark effect, is one of the promising candidates for realizing ultrafast optical switches. However, the ultrafast modulations induced by the coherent light−matter interactions usually involve unwanted incoherent responses, significantly reducing the overall operation speed. Here, by using ultrafast pump−probe spectroscopy, we suppress the incoherent response and modulate the coherent-to-incoherent ratio in the twodimensional semiconductor ReS 2 . We selectively convert the coherent and incoherent responses of an anisotropic exciton state by solely using photon polarizations, improving the control ratio by 3 orders of magnitude. The efficient modulation was enabled by transient superpositions of differential spectra from two nondegenerate exciton states due to the light polarization dependencies. This work provides a valuable contribution toward realizing ideal ultrafast optical switches.
Quantum optoelectronic devices capable of isolating a target degree of freedom (DoF) from other DoFs have allowed for new applications in modern information technology. Many works on solid-state spintronics have focused on methods to disentangle the spin DoF from the charge DoF, yet many related issues remain unresolved. Although the recent advent of atomically thin transition metal dichalcogenides (TMDs) has enabled the use of valley pseudospin as an alternative DoF, it is nontrivial to separate the spin DoF from the valley DoF since the time-reversal valley DoF is intrinsically locked with the spin DoF. Here, we demonstrate lateral TMD-graphene-topological insulator hetero-devices with the possibility of such a DoF-selective measurement. We generate the valley-locked spin DoF via a circular photogalvanic effect in an electric-double-layer WSe transistor. The valley-locked spin photocarriers then diffuse in a submicrometre-long graphene layer, and the spin DoF is measured separately in the topological insulator via non-local electrical detection using the characteristic spin-momentum locking. Operating at room temperature, our integrated devices exhibit a non-local spin polarization degree of higher than 0.5, providing the potential for coupled opto-spin-valleytronic applications that independently exploit the valley and spin DoFs.
Resolving the complex interplay between surface and bulk response is a long-standing issue in the topological insulators (TIs). Some studies have reported surface-dominated metallic responses, yet others show semiconducting-like bulk photoconductance. Using ultrafast terahertz spectroscopy with the advent of Fermi-level engineered TIs, we discovered that such difference arises from the time-dependent competing process of two parameters, namely, the Dirac-carrier surface scattering rate and the bulk Drude weight. After infrared femtosecond pulse excitation, we observed a metal-like photoconductance reduction for the prototypical n-type Bi2Se3 and a semiconductor-like increased photoconductance for the p-type Bi2Se3. Surprisingly, the bulk-insulating Bi2Se3, which is presumably similar to graphene, exhibits a semiconducting-to-metallic phase apparent transition at 10 ps. The sign-reversed, yet long-lasting (≥500 ps) metallic photoconductance was observed only in the bulk-insulating Bi2Se3, indicating that such dynamic phase transition is governed by the time-dependent competing interplay between the surface scattering rate and the bulk Drude weight. Our observations illustrate new photophysical phenomena of the photoexcited-phase transition in TIs and demonstrate entirely distinct dynamics compared to graphene and conventional gapped semiconductors.
van der Waals (vdW) heterostructures provide a powerful method to control the alignment of energy bands of atomically thin 2D materials. Under light illumination, the optical responses are dominated by Coulomb-bound electron−hole quasiparticles, for example, excitons, trions, and biexcitons, whose contributions accordingly depend on the types of heterostructures. For type-II heterostructures, it has been well established that light excitation results in electrons and holes that are separated in different layers, and the radiative recombination is dominated by the interlayer excitons. On the contrary, little is known about the corresponding optical responses of type-I cases. Understanding the optical characteristics of type-I heterostructures is important to the full exploration of the quasiparticle physics of the 2D heterostacks. In this study, we performed optical spectroscopy on type-I vdW heterostacks composed of monolayer MoTe 2 and WSe 2 . Photoluminescence and reflection contrast spectroscopy show that the light absorption and emission are dominated by the Coulomb-bound trions. Importantly, we observed that the MoTe 2 trion emission gets stronger compared with the exciton emission under resonant light excitation to the WSe 2 trion absorption state, especially in the WSe 2 /MoTe 2 /WSe 2 heterotrilayer. A detailed study of photoluminescence excitation further reveals that the chargetransfer mechanism is likely responsible for our observation, which differs from the exciton-dominated dipole−dipole energy transfer in type-II structures. Our demonstration implies that the type-I vdW heterostack provides new opportunities to engineer the light− matter interactions through many-body Coulomb-bound states.
The fields of layered material research, such as transition-metal dichalcogenides (TMDs), have demonstrated that the optical, electrical and mechanical properties strongly depend on the layer number N. Thus, efficient and accurate determination of N is the most crucial step before the associated device fabrication. An existing experimental technique using an optical microscope is the most widely used one to identify N. However, a critical drawback of this approach is that it relies on extensive laboratory experiences to estimate N; it requires a very time-consuming image-searching task assisted by human eyes and secondary measurements such as atomic force microscopy and Raman spectroscopy, which are necessary to ensure N. In this work, we introduce a computer algorithm based on the image analysis of a quantized optical contrast. We show that our algorithm can apply to a wide variety of layered materials, including graphene, MoS 2 , and WS 2 regardless of substrates. The algorithm largely consists of two parts. First, it sets up an appropriate boundary between target flakes and substrate. Second, to compute N, it automatically calculates the optical contrast using an adaptive RGB estimation process between each target, which results in a matrix with different integer Ns and returns a matrix map of Ns onto the target flake position. Using a conventional desktop computational power, the time taken to display the final N matrix was 1.8 s on average for the image size of 1280 pixels by 960 pixels and obtained a high accuracy of 90% (six estimation errors among 62 samples) when compared to the other methods. To show the effectiveness of our algorithm, we also apply it to TMD flakes transferred on optically transparent c-axis sapphire substrates and obtain a similar result of the accuracy of 94% (two estimation errors among 34 samples).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.