Steady-state rates of ether formation from alcohols (1-propanol, 2-propanol, and isobutanol) on γ-Al2O3 at 488 K increase at low alcohol pressure (0.1–4.2 kPa) but asymptotically converge to different values, inversely proportional to water pressure, at high alcohol pressure (4.2–7.2 kPa). This observed inhibition of etherification rates for C2–C4 alcohols on γ-Al2O3 by water is mechanistically explained by the inhibiting effect of surface trimers composed of two alcohol molecules and one water molecule. Unimolecular dehydration of C3–C4 alcohols follows the same mechanism as that for ethanol and involves inhibition by dimers. Deuterated alcohols show a primary kinetic isotope effect for unimolecular dehydration, implicating cleavage of a C–H bond (such as the Cβ–H bond) in the rate-determining step for olefin formation on γ-Al2O3. Bimolecular dehydration does not show a kinetic isotope effect with deuterated alcohols, implying that C–O or Al–O bond cleavage is the rate-determining step for ether formation. The amount of adsorbed pyridine estimated by in situ titration to completely inhibit ether formation on γ-Al2O3 shows that the number of sites available for bimolecular dehydration reactions is the same for different alcohols, irrespective of the carbon chain length and substitution. 2-Propanol has the highest rate constant for unimolecular dehydration among studied alcohols, demonstrating that stability of the carbocation-like transition state is the primary factor in determining rates of unimolecular dehydration which concomitantly results in high selectivity to the olefin. 1-Propanol and isobutanol have olefin formation rate constants higher than that of ethanol, indicating that olefin formation is also affected by carbon chain length. Isobutanol has the lowest rate constant for bimolecular dehydration because of steric factors. These results implicate the formation and importance of di- and trimeric species in low-temperature dehydration reactions of alcohols and demonstrate the critical role of substitution and carbon chain length in determining selectivity in parallel unimolecular and bimolecular dehydration reactions.
The steady state rates of ethene and diethyl ether formation in parallel ethanol dehydration reactions at 573 and 623 K are mechanistically and kinetically described by the same rate expression on different alumina materials (α-, γ-, and η-Al 2 O 3 ), implying that alumina materials have similar surface sites under reaction environments. In situ chemical titration using pyridine as a titrant elucidates similar site densities (∼0.12 sites nm −2 and ∼0.07 sites nm −2 for ethene formation and ∼0.14 sites nm −2 and ∼0.09 sites nm −2 for diethyl ether formation on γ-and η-Al 2 O 3 , respectively) on γ-and η-Al 2 O 3 indicating that similar surface features exist on both γ-and η-Al 2 O 3 . Pyridine-ethanol co-feed experiments show that pyridine inhibited the formation of ethene to a greater extent than diethyl ether suggesting that the two parallel dehydration reactions are not catalyzed by a common active site.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.