This paper describes a method, which combines optical trapping and microfluidic-based droplet generation, for selectively and controllably encapsulating a single target cell or subcellular structure, such as a mitochondrion, into a picoliter- or femtoliter-volume aqueous droplet that is surrounded by an immiscible phase. Once the selected cell or organelle is encased within the droplet, it is stably confined in the droplet and cannot be removed. We demonstrate in droplet the rapid laser photolysis of the single cell, which essentially "freezes" the state that the cell was in at the moment of photolysis and confines the lysate within the small volume of the droplet. Using fluorescein di-beta-d-galactopyranoside, which is a fluorogenic substrate for the intracellular enzyme beta-galactosidase, we also assayed the activity of this enzyme from a single cell following the laser-induced lysis of the cell. This ability to entrap individual selected cells or subcellular organelles should open new possibilities for carrying out single-cell studies and single-organelle measurements.

This article discusses capillary forces measured by scanning force microscopy ͑SFM͒, which, as recently reported, show a discontinuous behavior at a low relative humidity between 20% and 40% depending on the solid surfaces. A capillary force discontinuity is very interesting in terms of a possible phase change or restructuring transition of bulk water in the interfacial solid-liquid region. Unfortunately, we have found that SFM measurements show an inherent weakness in the determination of the origin of the forces that are obtained during pull-off measurements. This article critically discusses the origin of the adhesive interactions as a function of relative humidity with chemically modified probing surfaces. Our measurements indicate that force discontinuities in pull-off measurements are strongly affected by the inability of the liquid to form capillary necks below a critical threshold in relative humidity. In the course of this article, we will discuss roughness effects on capillary forces and provide a modified capillary force equation for asperity nanocontacts.

This paper describes a method to concentrate solutes and colloidal entities, from small ions and molecules to proteins and nanoparticles, within individual aqueous microdroplets in oil. The mechanism lies in the entrapment of the solutes within an aqueous microdroplet, while the water molecules from the droplet slowly dissolve into the organic phase. Because the rate of change in concentration scales as the fifth power of the surface-area-to-volume ratio of the droplet, this phenomenon is prominent mostly in the micrometer-length scale. This paper presents measurements that quantify the degree of solute entrapment within the microdroplet and further describes the dynamics of droplet shrinkage and the factors that influence the rate of shrinkage. In addition, this paper explains why this concentration effect does not occur for certain organic microdroplets in aqueous solutions.

No abstract

This paper demonstrates the ability to use capillary electrophoresis (CE) separation coupled with laser-induced fluorescence for analyzing the contents of single femtoliter-volume aqueous droplets. A single droplet was formed using a T-channel (3 microm wide by 3 microm tall) connected to microinjectors, and then the droplet was fluidically moved to an immiscible boundary that isolates the CE channel (50 microm wide by 50 microm tall) from the droplet generation region. Fusion of the aqueous droplet with the immiscible boundary effectively injects the droplet content into the separation channel. In addition to injecting the contents of droplets, we found aqueous samples can be introduced directly into the separation channel by reversibly penetrating and resealing the immiscible partition. Because droplet generation in channels requires hydrophobic surfaces, we have also investigated the advantages to using all hydrophobic channels versus channel systems with patterned hydrophobic and hydrophilic regions. To fabricate devices with patterned surface chemistry, we have developed a simple strategy based on differential wetting to deposit selectively a hydrophilic polymer (poly(styrenesulfonate)) onto desired regions of the microfluidic chip. Finally, we applied our device to the separation of a simple mixture of fluorescein-labeled amino acids contained within a approximately 10-fL droplet.