No abstract

No abstract

Prewhirl regulation by inlet guide vanes (IGVs) has been proven as an effective method for operation regulation of centrifugal pumps. By contrast, the influence of the geometry of IGVs on operation stability of centrifugal pump remains unknown. The pressure fluctuations and flow patterns in a centrifugal pump without and with two-dimensional (2D) or three-dimensional (3D) IGVs are investigated numerically at 1.0Qd, 0.6Qd, and 1.2Qd. Renormalization group (RNG) k–ε turbulence model is used as turbulence model, and fast Fourier transform (FFT) method is used to analyze the pressure fluctuations. The dominant frequency of pressure fluctuations in impellers is either the rotational frequency fi or twice thereof for pumps without and with IGVs at three flow rates, while the dominant frequency is constantly the blade passing frequency in volute. For 1.0Qd, the comparison of pumps without IGVs indicates that the maximum amplitude of pressure fluctuations at fi in pumps with 2D IGVs is decreased by an average of 22.2%, and the amplitude is decreased by an average of 44.9% in pumps with 3D IGVs. The IGVs mainly influence the pressure fluctuations at fi but indicate minimal influence at 2fi. For 0.6Qd, the comparison of pumps without IGVs denotes that the maximum amplitudes of pressure fluctuations at fi in pumps with 2D or 3D IGVs both increase; the maximum increase is 2.01%. For 1.2Qd, the comparison of pumps without IGVs indicates that the maximum amplitudes of pressure fluctuations at fi in pumps with 2D or 3D IGVs both decrease; the maximum decline is 15.9%.

The (LaBa)Co2O5+δ thin films were grown on (001) SrTiO3 single crystal substrates by using pulsed laser deposition. Microstructure studies from x-ray diffraction and electron microscopy show that the films have good epitaxial quality with a-axis orientation and sharp atomic interface. Transport property and isothermal magnetoresistance measurements have been used to understand the physical properties of the films with anomalous magnetic phenomena and the largest reported magnetoresistance value of 19% at 40 K.

The cavitating flow around the asymmetric leading edge (ALE) 15 hydrofoil is investigated through large eddy simulation with the modified Schnerr–Sauer cavitation model, which considers the effect of noncondensable gas. The statistical average velocity profiles obtained by simulation and experimentation show good agreement. The time evolution of cavity shape shows that cavity growth and separation start from the short side and spread toward the long side due to a side-entrant jet. The variation frequency of the cavity length of ALE15 hydrofoil at the long side is 163.93 Hz, and the cavitation shedding frequency at the short side is 306.67 Hz, which is about twice the value of the former. The filtered vorticity transport equation is employed to investigate the cavitation–vortex–turbulence interaction. Results indicate that vortex stretching is the major promoter of cavitation development, and vortex dilatation links vapor cavity and vortices. Baroclinic torque is noticeable at the liquid–vapor interface, and turbulent stress is related to cavitation inception. Moreover, a one-dimensional model for predicting pressure fluctuation is proposed, and results show that the model can effectively predict cavitation-induced pressure fluctuation on a hydrofoil, even on a three-dimensional ALE15 hydrofoil.

No abstract

No abstract

Highly epitaxial LaBaCo2O5.5+δ (LBCO) thin films were grown on different miscut (001) SrTiO3 substrates (miscut angle of 0.5°, 3.0°, and 5.0°) to study the substrate surface step terrace effect on the in-plane electrical transport properties. The microstructure studies by X-ray diffraction and transmission electron microscopy indicate that the as-grown films are A-site disordered cubic perovskite structures with the c-axis highly oriented along the film growth direction. The four-probe scanning tunneling microscopy (STM) studies show that the LBCO thin films grown on the vicinal SrTiO3 substrates have a typical semiconductor behavior with the substrate surface terrace step inducing anisotropic electronic transport properties. These results indicate that in highly epitaxial thin films the surface terrace step induced local strains can play an important role in controlling the electronic transport properties and the anisotropic nature.