High energy-density lithium-ion batteries are in demand for portable electronic devices and electrical vehicles. Since the energy density of the batteries relies heavily on the cathode material used, major research efforts have been made to develop alternative cathode materials with a higher degree of lithium utilization and specific energy density. In particular, layered, Ni-rich, lithium transition-metal oxides can deliver higher capacity at lower cost than the conventional LiCoO2 . However, for these Ni-rich compounds there are still several problems associated with their cycle life, thermal stability, and safety. Herein the performance enhancement of Ni-rich cathode materials through structure tuning or interface engineering is summarized. The underlying mechanisms and remaining challenges will also be discussed.

Tremendous research works have been done to develop better cathode materials for a large scale battery to be used for electric vehicles (EVs). Spinel LiMn2O4 has been considered as the most promising cathode among the many candidates due to its advantages of high thermal stability, low cost, abundance, and environmental affinity. However, it still suffers from the surface dissolution of manganese in the electrolyte at elevated temperature, especially above 60 °C, which leads to a severe capacity fading. To overcome this barrier, we here report an imaginative material design; a novel heterostructure LiMn2O4 with epitaxially grown layered (R3̅m) surface phase. No defect was observed at the interface between the host spinel and layered surface phase, which provides an efficient path for the ionic and electronic mobility. In addition, the layered surface phase protects the host spinel from being directly exposed to the highly active electrolyte at 60 °C. The unique characteristics of the heterostructure LiMn2O4 phase exhibited a discharge capacity of 123 mAh g(-1) and retained 85% of its initial capacity at the elevated temperature (60 °C) after 100 cycles.

Li-rich materials are considered the most promising for Li-ion battery cathodes, as high energy densities can be achieved. However, because an activation method is lacking for large particles, small particles must be used with large surface areas, a critical drawback that leads to poor long-term energy retention and low volumetric energy densities. Here we propose a new material engineering concept to overcome these difficulties. Our material is designed with 10 μm-sized secondary particles composed of submicron scaled flake-shaped primary particles that decrease the surface area without sacrificing rate capability. A novel activation method then overcomes the previous limits of Li-rich materials with large particles. As a result, we attained high average voltage and capacity retention in turn yielding excellent energy retention of 93% during 600 cycles. This novel and unique approach may furthermore open the door to new material engineering methods for high-performance cathode materials.

A nano-scale surface protecting layer of LiNi0.8Co0.15Al0.05O2 consisting of substituted V4+ ions in 3b sites leads to structural robustness under the most challenging test conditions.

ABSTRACT:We developed the novel electrode that enables fine control of overpotential by exploiting surface segregation that is the enrichment of one component at the surface of binary alloy. To realize this approach, we controlled the proportion of Si with low Li diffusivity at the surface by annealing the SiGe nanowire in H 2 environment at various temperatures. The resulting SiGe nanowires annealed at 850°C exhibited high reversible capacity (>1031 mA·h·g −1 ), and long cycle life (400 cycles) with high capacity retention (89.0%) at 0.2 C. This superior battery performance is attributed to the remaining unlithiated part acting as support frame to prevent pulverization of anode material, which results from the fine-tuning of overpotential by controlling the degree of Si segregation.