Injection molding is one of the most widely‐used processes for the production of plastic parts, due to the utilization of diverse materials, the complex product‐shape moldability, and the rapid mass production. In relation to the environmental issues, light‐weight technology and green molding solutions are becoming more important. Microcellular injection molding technology is one of the green molding solutions for saving materials, as well as reducing the weight of molded parts. However, the molding process brings about some defects, including a sliver flow mark on the surface and uneven mechanical properties that are caused by the uneven cell size and their distribution within the part. Dynamic molding temperature control technology seems to be an effective way of improving the product quality. Until recently, there has been very little discussion about high‐efficiency cooling methods. A new complex mold for a cooling system has been designed. The basis cooling ability of different materials was investigated. The complex mold design has a faster cooling rate, and it has a greater surface temperature uniformity. This cooling technology was used to improve the quality of microcellular injection molded parts, which improves the glossy finish by about 73%. The results show that the faster cooling rate brings about the more uniform cell size with higher cell density from 9.43E+11 to 1.92E+12 cells/cm3. Otherwise, the cell size reduced from 192.92 to 84.97 μm.
The industrial developments have led to more applications of various composites. Since fiber orientation and distribution will influence product performance in composites, controlling said orientation and distribution is of critical importance. This study used external magnetic fields to control the fiber orientation and distribution in a polymer. The orientation of the actual fibers under magnetic field control during flowing was observed using a visualization system, which was made by PMMA and transparent epoxy as an upper cover and filling polymer. In order to clearly observe and calculate, 0.1 wt% fiber content was used, and 0.3 wt% fiber content was used to measure conductivity. Fiber distribution angles without a magnetic field concentrate parallel to the flow direction (0° ~ 30° and 151° ~ 180°) while distribution angles under magnetic field control were concentrated along the magnetic field direction, which was perpendicular to the flow direction (61° ~ 120°). The higher the magnetic flux density, the larger the torque of the electromagnetic field on the fibers and the higher the orientation of fibers was with the magnetic field. The electrical conductivity was 12.23 times higher for 1 mm fibers in an external magnetic field versus no magnetic field.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.