ABSTRACT. This work suggests the study of the coagulation diagram as a tool to verify the efficiency in removing color and turbidity of the water, using the Moringa oleifera Lam and the association of this biopolymer with the aluminium sulphate as coagulating agents. The assays were carried out in Jar Test, by varying the concentrations of coagulants and pH of coagulation. After the assays of coagulation/flocculation/sedimentation, samples were collected for the evaluation of the process efficiency. Best results were obtained at dose of 50 ppm of Moringa oleifera Lam. When associating the coagulants, the addition of the aluminium sulphate provided an increase in the efficiency of coagulation/flocculation, whose parameters of control used were color and turbidity. It was verified that the study of the coagulation diagram is useful, since it enables developing the assays in the optimal range, as a function of the raw water characteristics. The use of the Moringa oleifera Lam can be considered as an alternative technique to the conventional treatment.Keywords: water treatment, biopolymer, chemical coagulant, quality parameters.Diagramas de coagulação utilizando a Moringa oleifera Lam e o sulfato de alumínio, visando a remoção de cor e turbidez da água RESUMO. Este trabalho propõe o estudo dos diagramas de coagulação como ferramenta para verificar a eficiência de remoção de cor e turbidez da água bruta, utilizando como coagulante a Moringa oleifera Lam e a associação deste biopolímero com o sulfato de alumínio. Os ensaios foram realizados em Jar Test, variandose as concentrações dos coagulantes e o pH de coagulação. Após os ensaios de coagulação/ floculação/sedimentação, foram coletadas amostras para a avaliação da eficiência do processo. Os melhores resultados obtidos para os parâmetros avaliados corresponderam a uma dosagem de solução padrão de Moringa oleifera Lam equivalente a 50 ppm. Quando da associação dos coagulantes, a adição do sulfato de alumínio proporcionou um aumento na eficiência da coagulação/floculação, cujos parâmetros de controle utilizados foram cor e turbidez. Verificou-se que o estudo do diagrama de coagulação é útil, pois possibilita o desenvolvimento dos ensaios nas regiões ótimas, em função das características da água bruta. A utilização da Moringa oleifera Lam pode ser considerada como uma técnica alternativa ao tratamento convencional.Palavras-chave: tratamento de água, biopolímero, coagulante químico, parâmetros de qualidade.

The objective of this study was to evaluate the water quality of the Caiabi River based upon the water quality index (WQI) and the trophic state index (TSI), considering seasonal and spatial variations, with the aim of determining the most appropriate monitoring design for this study site. Sampling for water quality monitoring was conducted at five points on the 163 Índices de qualidade da água e …

The present study aims to optimize the operational conditions in surface water coagulation/flocculation and sedimentation step, besides evaluating the association between seeds of Moringa oleifera Lam. (M. oleifera) and the synthetic coagulant aluminium sulphate for surface water treatment. The assays were performed in Jar Test using surface water from Pirapó River basin, Maringá, PR. It was observed that the operational conditions affect the coagulation/flocculation and sedimentation process efficiency. Optimal operational conditions for coagulants association are as follows: rapid mixing velocity (RMV) of 105 rpm, rapid mixing times (RMT) of 1 min, slow mixing velocity (SMV) of 30 rpm, slow mixing times (SMT) of 15 min, and sedimentation time (ST) of 15 min; this enables an improvement in the process, contributing to a reduction in synthetic coagulant aluminium sulphate demand of up to 30%, combined with an increase in M. oleifera dosage, not affecting the coagulation/flocculation and sedimentation process efficiency, considering the water pH range between 7 and 9.

This study aimed to evaluate the efficiency of the coagulation/flocculation/dissolved air flotation (C/F/DAF) process using the coagulant Moringa oleifera (MO) seed powder, and to analyse the profile of fatty acids present in the generated sludge after treatment. For the tests, deionized water artificially contaminated with cell cultures of Anabaena flos-aquae was used, with a cell density in the order of 10(4) cells mL(-1). C/F/DAF tests were conducted using 'Flotest' equipment. For fatty acid profile analyses, a gas chromatograph equipped with a flame ionization detector was used. It was seen that the optimal dosage (100 mg L(-1)) of MO used in the C/F/DAF process was efficient at removing nearly all A. flos-aquae cells (96.4%). The sludge obtained after treatment contained oleic acid (61.7%) and palmitic acid (10.8%). Thus, a water treatment process using C/F/DAF linked to integral MO powder seed was found to be efficient in removing cells of cyanobacteria, and produced a sludge rich in oleic acid that is a precursor favourable for obtaining quality biodiesel, thus becoming an alternative application for the recycling of such biomass.

The objective of this study is to investigate the impacts of anionic polymer as a flocculant aid on the coagulation/flocculation performance with a saline solution of Moringa oleifera as a coagulant to provide larger flocs and decrease the time sedimentation. For the tests, raw water was used from Pirapó River Basin (Maringá, Paraná, Brazil). Optimization of coagulation/flocculation tests was initially performed in a jar-test with a dosage of M. oleifera Lam (crude extract--MO, oil-extracted with ethanol--MO (et) and hexane--MO (hex) 1% m/v) as the coagulant that ranged from 10 to 60 mg L(-1) and of the anionic polymer 0.1% as a flocculant aid with a dosage that ranged from 0 to 0.4 mg L(-1). The parameters analysed were colour, turbidity and compounds with absorption in UV254nm. In view of the statistical analysis results, MO (hex) with a dosage of 30 mg L(-1) was chosen as a coagulant for the next tests of coagulation/flocculation. When anionic polymer was used alone (0.0 mg L(-1) of MO (hex)), parameters were not removed and there was no generation of heavy flocs as compared with the combination of MO (hex) with the anionic polymer. Statistical analysis showed that MO (hex) obtained the highest removals of the parameters analysed in lower dosages and no significant increase in parameters removal was observed when the polymer dosage was increased. The efficacy of the coagulant +/- anionic polymer was optimal when 30mg L(-1) of MO (hex) was used as a coagulant and 0.1 mg L(-1) of the anionic polymer was used as a flocculant aid, decreasing the time sedimentation from 1 h to 15 min.