No abstract

The possibility to utilize non-additive genetic gain in planting stock has increased the interest towards vegetative propagation. In Finland, the increased planting of Norway spruce combined with fluctuant seed yields has resulted in shortages of improved regeneration material. Somatic embryogenesis is an attractive method to rapidly facilitate breeding results, not in the least, because juvenile propagation material can be cryostored for decades. Further development of technology for the somatic embryogenesis of Norway spruce is essential, as the high cost of somatic embryo plants (emblings) limits deployment. We examined the effects of maturation media varying in abscisic acid (20, 30 or 60 µM) and polyethylene glycol 4000 (PEG) concentrations, as well as the effect of cryopreservation cycles on embryo production, and the effects of two growing techniques on embling survival and growth. Embryo production and nursery performance of 712 genotypes from 12 full-sib families were evaluated. Most embryos per gram of fresh embryogenic mass (296 ± 31) were obtained by using 30 µM abscisic acid without PEG in the maturation media. Transplanting the emblings into nursery after one-week in vitro germination resulted in 77% survival and the tallest emblings after the first growing season. Genotypes with good production properties were found in all families.

Research Highlights: The Norway spruce somatic embryogenesis (SE) pipeline is suitable for multiplication of material with root rot resistance traits. Background and Objectives: Heterobasidion root rot is the economically most severe forest pathogen in Europe, reducing the benefit of planting elite forest material. In this study, the SE-propagation ability of elite Norway spruce material carrying root rot resistance traits was studied. Materials and Methods: We analyzed the presence of the root rot resistance locus PaLAR3B among 80 Finnish progeny-tested Norway spruce plus-trees used for SE-plant production as well as in 241 SE lines (genotypes) derived from them. Seven full-sib families with lines having either AA, AB, or BB genotype for PaLAR3 locus were further studied for their SE-plant propagation ability. Results: The results indicate that 43.8% of the studied elite trees carry the PaLAR3B allele (41.3% are heterozygous and 2.5% homozygous). The resistance allele was present among the SE lines as expected based on Mendelian segregation and did not interfere with somatic embryo production capacity. All embryos from PaLAR3 genotypes germinated well and emblings were viable in the end of first growing season. However, in three families, PaLAR3B homo- or heterozygotes had 23.2% to 32.1% lower viability compared to their respective hetero- or PaLAR3A homozygotes. Conclusions: There is no trade-off between root rot resistance locus PaLAR3B and somatic embryo production ability, but the allele may interfere with Norway spruce embling establishment.

Somatic embryogenesis has already been used for Norway spruce (Picea abies (L.) Karst) embling production on a laboratory scale, but automation is needed to increase efficiency and reduce costs. One option to scale up production is mass production in bioreactors. In a series of experiments, a pro-embryogenic mass was propagated using Plantform temporary immersion system bioreactors, and the effect of different aeration cycles, support pad materials, and post-maturation treatments (rinsing and desiccation) on the embryo yield and embling survival after 4 to 6 mo in a greenhouse was tested. Three genotypes were used to test each treatment. The best aeration frequency was 20 min every 4 h, while a lower or higher frequency did not generally improve embryo production. Filter paper on plastic netting was the best support pad material in terms of usability and embryo production (varying from 177 ± 20 to 696 ± 109 per g pro-embryogenic mass). The separation of the embryos from the undeveloped cell mass by rinsing with sterile water resulted in reduced survival of the emblings. Desiccation treatment on nested plates with the embryos on the inner plate with or without filter paper improved their survival. Bioreactors were laborious to prepare, load, and clean. Improvements in embryo production can be achieved by optimizing the process, but bioreactors based on the requirements of somatic embryogenesis are needed to enable their use in the mass production of Norway spruce emblings.

Somatic embryogenesis is being piloted for the commercial production of genetically improved Norway spruce (Picea abies L. Karst) forest regeneration material in Finland. The main challenge to making the process commercially relevant is the dependence on time-consuming and highly skilled manual labor. Automation and scaling up are needed to improve cost-effectiveness. Moving from the proliferation of embryogenic tissue on semisolid media to suspension cultures could improve process scalability. In a series of four experiments (overall, with 20 cell lines, 4–9 per experiment), the suitability of proliferation in suspension culture for Norway spruce somatic embryogenesis was evaluated based on the growth rate, indicators of stress conditions, good-quality cotyledonary embryo yield, and embling survival in a greenhouse. The proliferation rate in suspension was found equal to on semisolid media, but with a remarkable genotypic variation. Embryogenic tissue matured directly without pre-treatments from suspension onto semisolid media produced lower numbers of good-quality embryos than tissue matured from semisolid media. Rinsing the suspension-grown tissue with hormone-free liquid media before maturation improved embryo yield, bringing it closer to that of semisolid-grown tissue. Decreasing 6-benzylaminopurine and 2,4-dichlorophenoxyacetic acid concentrations in suspension proliferation media to 0.5 or 0.1 times those in semisolid media did not affect tissue growth and did not improve embryo production. The hydrogen peroxide (H2O2) content and guaiacol peroxidase activity were elevated in suspension cultures compared with semisolid medium, which had the same plant growth regulator content. In one experiment out of four, the greenhouse survival of germinants was lower when proliferation was carried out in full strength suspension than on semisolid media; in other experiments the survival rates were equal.

For Norway spruce (Picea abies (L.) Karst.) somatic embryogenesis (SE) culture conditions throughout the propagation process affect the final result. Many critical phases can be identified, and all of them cumulatively increase the production costs of SE plants if they cannot be controlled. In order to determine the best lighting protocol for each SE step, Norway spruce embryogenic tissue (ET) was proliferated, and somatic embryos were matured under different light wavelengths, wavelength combinations, and in the dark. Overall, using low-intensity LED lights during proliferation or at the end of maturation had little effect on the growth of ET, embryo productivity, or embryo survival; on the other hand, major negative effects could not be seen. This is beneficial from a practical point of view, indicating no need for lighting or protection of SE cultures from light during their handling in these steps of the propagation process. When somatic embryos were germinated under different spectra, significant differences in embling shoot and root growth, as well as in the survival of the emblings, were found. The best treatment varied between trials, and the genotype of the SE culture was found to have a stronger effect than the light spectrum, indicating that various light spectra and also intensity adjusted using pulse width modulation (PWM) can be successfully applied to the SE germination phase in Norway spruce.

The aim of this work was to improve the protocol of somatic embryogenesis (SE) and propagation efficiency in Norway spruce (Picea abies (L.) Karst.), which would enable the integration of SE into Finnish breeding programme and the nursery practices applied to seedlings. The studies specifically investigated the following three areas: i) how maturation, cold storage, germination and growing conditions (laboratory-nursery interface) affect the survival and height growth of emblings (Papers I and II); ii) how to improve the efficiency of embling production from genotypes from wide genetic backgrounds (Papers I and II); and iii) how to increase propagation efficiency by rooting cuttings from emblings, and produce field testing material by combining SE and the rooting of cuttings (Papers II and III). To evaluate the possibility of improving the efficiency of SE in the laboratory-nursery interface, a series of experiments were conducted. The cost structure of SE, and the effects of improvements on costs, was estimated. As a result, the protocol improvements doubled the yield of cotyledonary embryos, nearly doubled embling survival, and increased the height growth of emblings in the nursery by so much that sufficient planting height was reached one year less than before. Emblings were also obtained from 356 genotypes (50% thawed), and embling cuttings rooted well in conditions similar to those used for seedling cuttings. The protocol improvements also reduced embling production costs by 75%. Based on this work, emblings may be grown in nurseries after one week of in vitro germination, without any measures that differ from seedlings after transplanting. Propagation efficiency may be further increased by rooting embling cuttings. Furthermore, large-scale clone testing can be initiated with 5-12 emblings acting as cutting donors.

Vegetative propagation opens opportunities for the multiplication of elite tree progeny for forest regeneration material. For conifers such as Norway spruce (Picea abies) the most efficient vegetative propagation method is seed multiplication through somatic embryogenesis. Efficient culture methods are needed for somatic embryogenesis to be commercially viable. Compared to culturing as clumps, filter disc cultures can improve the proliferation of embryogenic tissue (ET) due to more even spread and better developmental synchronization. In this study, ET proliferation on filter discs was compared to proliferation as clumps. The study comprised 28 genotypes in four trials. The benefits of adding a pre-maturation step and the selection of fresh ET for the subculture were evaluated. Pre-maturation on hormone-free media before maturation did not significantly improve embryo yield but improved greenhouse survival from 69% to 80%, although there was high variation between lines. Filter disc cultivation of ET did result in better growth than in clumps but was more dependent on ET selection and the amount of ET than the clump cultivation method. Filter proliferation also favors certain lines. Post-maturation storage can be used to change the storage compound composition of the produced mature embryos. The embryo storage compound profile was analyzed after post-maturation cold storage treatments of 0, 4, 8, 31, and 61 weeks and compared to that of the zygotic embryos. Cold storage made the storage compound profile of somatic embryos closer to that of zygotic embryos, especially regarding the raffinose family oligosaccharides and storage proteins. Sucrose, hexose, and starch content remained higher in somatic embryos even through cold storage. Prolonged storage appeared less beneficial for embryos, some of which then seemed to spontaneously enter the germination process.