Calculation models for the selection of cable lines used for expansion and modernization in the energy system and energy transmission planning are recognized tools supporting decision-making in both the energy sector and energy policy. At the same time, the above calculation models contain a large number of correction factors taking into account the temperature of the external environment at various points, the mutual influence of which is not taken into account. This means limitations to today’s common approaches to solutions, especially with regard to the required safety buffer for cable line selection. To meet this challenge, this article presents a parameter that takes into account the change and difference in temperature at various points in the external environment in the analyzed cable line systems. The purpose of this paper was to develop a new approach to the selection of a cable line in order to minimize failure during operation. For this purpose, possible temperature cases that may occur during line operation in different countries and at different rated voltages have been identified. Simulation models for individual cable line layouts were developed and the extreme temperature cases of the line operation for the maximum negative and positive temperature difference between the cable core and the external environment were considered in detail. The development of the curve of the change of the correction factor for the difference in the operating temperature of the cable line will allow for a more precise selection of the cable line parameters and the shortening of the current calculation model in terms of cable selection. In addition, this article presents a comparison of the change in the value of the correction factor from the change in temperature of a selected phase of a cable line system.
This article presents an analysis of the reliability of the power grid using data on the failure rate of the medium voltage (MV) power grid from the last five years. The analysis of the state of the power grid was based on the data provided by the grid operator. The purpose of this article is to analyze the reliability assessment of the medium voltage (MV) power connections using various analytical methods, a simulation model and reliability indicators. The analysis was performed based on the defined categories of power outages in terms of their duration. This made it possible to determine the energy quality indicators in a selected power grid. Then, a more complex analysis was carried out to assess the convergence of the applied analytical models of reliability assessment with the actual results obtained for the power grid. Moreover, using ANSYS Multiphysics, a numerical model of the cable head was developed to analyze the processes taking place in this element of the power grid for various exploitation cases.
Several algorithms are presented in the article for the transformation of numerical matrices by nonstandard means. These algorithms are shown in the data encryption task, namely, a text message with a certain set of characters. An analysis of the effectiveness of the proposed approach will be demonstrated by comparing open source and encrypted. The algorithms developed by the author are described in as detailed and clear as possible, since they are new. At the same time, they can be difficult to reach or incorrectly interpreted by those who do not have the full amount of information about them.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.