The paper provides an outlook on future directions of research and the possible applications for pulverized coal-fired boilers. One potential direction for future research is to focus on the ways to improve the efficiency of pulverized coal-fired boilers. This could involve developing new combustion technologies that are able to more thoroughly burn the coal and produce less waste or finding ways to capture and use the excess heat that is generated during the combustion process. The pulverized coal combustion process in power boilers is still being improved by the preliminary cleaning of coal and the use of various catalytic additives. Another area of research that could be valuable is the development of advanced control systems and monitoring technologies for pulverized coal-fired boilers. These systems could be used to optimize the performance of the boiler and ensure that it is operating at maximum efficiency while also providing real-time data on the condition of the boiler and any potential problems that may arise. The analysis of literature shows that several future paths of development and scientific research related to the technology of pulverized coal combustion in boilers can be distinguished.
The review presents the D2-law of droplet evaporation, which is used to describe the spraying process involving the evaporation of droplets. This law, the subject of numerous publications, can be successfully applied to describe the droplet evaporation process under various conditions, including the calculations of the process of feeding the boiler with a liquid that contains catalyst particles. To date, not a lot of work has been devoted to this issue. The paper is a continuation of previous research concerning the spraying of liquids with a catalyst, which improves the efficiency of the process. The conducted analysis showed that the experimental data from previously published work are very compatible with the data obtained from the D2-law of droplet evaporation. At the standard speed of about 20 m/s of an aerosol flowing through a dust duct, droplets in the stream should be observed up to a distance of 1 m from the outlet of the apparatus supplying the system. Under such flow conditions, a droplet’s lifetime must be above 0.05 s. The dependence between a droplet’s lifetime and its diameter and temperature was determined. The obtained results confirmed that the effective droplet diameter is above 30 µm. Such droplets must be generated and then fed to the boiler for the catalyst to work properly. This law is an engineering approach to the problem, which uses relatively simple model equations in order to determine the evaporation time of a droplet.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.