Continuumrobotic manipulators articulate due to their inherent compliance. Tendon actuation leads to compression of the manipulator, extension of the actuators, and is limited by the practical constraint that tendons cannot support compression. In light of these observations, we present a new linear model for transforming desired beam configuration to tendon displacements and vice versa. We begin from first principles in solid mechanics by analyzing the effects of geometrically nonlinear tendon loads. These loads act both distally at the termination point and proximally along the conduit contact interface. The resulting model simplifies to a linear system including only the bending and axial modes of the manipulator as well as the actuator compliance. The model is then manipulated to form a concise mapping from beam configurationspace parameters to n redundant tendon displacements via the internal loads and strains experienced by the system. We demonstrate the utility of this model by implementing an optimal feasible controller. The controller regulates axial strain to a constant value while guaranteeing positive tendon forces and minimizing their magnitudes over a range of articulations. The mechanics-based model from this study provides insight as well as performance gains for this increasingly ubiquitous class of manipulators.

Abstract

AbsIracr-In recent years, many successful robotic manipulator designs have been introduced. However, there remains the challenge of designing a manipulator that possesses the inherent safety characteristics necessary for human-centered robotics. In this paper, we present a new actuation approach that has the requisite characteristics for inherent safety while maintaining the performance expected of modern designs. By drastically reducing the effectire impedance of the manipulator while maintaining high frequency torque capability, we show that the competing design requirements of performance and safety can be successfully integrated into a single manipulation system.

No abstract

No abstract

No abstract

No abstract

Continuum manipulators are gaining widespread acceptance in commercial robotics, particularly in the medical field, where their compliance allows a large benefit for patient safety. However, this compliance also makes precise position control of these manipulators quite difficult. This paper presents two closed-loop control implementations applied to a small scale continuum manipulator. These implementations are both based on manipulator tip position feedback from an electromagnetic sensor.The command tracking and disturbance rejection properties of the two control implementations are shown to be approximately equivalent, and provide improved position control when compared to open-loop control, without sacrificing system stability.