In urban cities, the environmental services are the responsibility of the public sector, where piped water supply is the norm for urban household. Likewise, in Beirut City (capital of Lebanon) official water authorities are the main supplier of domestic water through a network of piping system that leaks in many areas. Beirut City and its suburbs are overpopulated since it is the residence of 1/3 of the Lebanese citizens. Thus, Beirut suffers deficiency in meeting its water demand. Water rationing, as a remedial action, is firmly established since four decades by the Lebanese Water Authorities. Consumers resorted then to private wells to supplement their domestic water needs. Consequently, household water quality is influenced by external factors relating to well water characteristics and internal factors depending on the types of the pipes of the distribution network and cross connections to sewer pipes. These factors could result in chemical and microbial contamination of drinking water. The objective of this study is to investigate domestic water quality variation in Beirut City emerging form the aforementioned factors. The presented work encircles a typical case study of Beirut City (Ras Beirut). Results showed deterioration pattern in domestic water quality. The predicted metal species and scales within the water pipes of distribution network depended on water pH, hardness, sulfate, chloride, and iron. The corrosion of iron pipes mainly depended on Mg hardness.
Determination of only total element in sediments does not give an accurate estimate of the likely environmental impacts. Speciation study of metals in sediment provides information on the potential availability of metals (toxic) to biota under various environmental conditions. In water, the toxic metal specie is the free hydrated metal ion. The toxicity of metals depends especially on their chemical forms rather than their total metal content. The present study focuses on Qaraaoun Reservoir, Lebanon. Earlier studies focused only on total metal concentrations in sediment and water. The objective of this study was to determine metal speciation (Fe, Cr, Ni, Zn, Cu, Pb, Cd) in the (operationally defined) sediment chemical fractions and metal speciation in reservoir water. This would reflect on metal bioavailability and toxicity. Water samples and bed sediments were collected from nine sites during the dry season and a sequential chemical fraction scheme was applied to the <75-μm sieve sediment fraction. Metal content in each fraction was determined by the FAAS technique. The data showed that the highest percentages of total metal content in sediment fractions were for: Fe in residual followed by reducible, Cr and Ni in residual and in reducible, Cu in organic followed by exchangeable, Zn in residual and in organic, Pb in organic and carbonate, Cd was mainly in carbonate. Total metal content in water was determined by ICP-MS technique and aqueous metal speciation was predicted using AQUACHEM software interfaced to PHREEQC geochemical computer model. The water speciation data predicted that a high percentage of Pb and Ni were present as carbonate complex species and low percentages as free hydrated ions, highest percentage of Zn as carbonate complex species followed by free hydrated ion, highest percentage of Cd as free hydrated ion followed by carbonate complex species. The sensitivity attempt of free hydrated ion of Ni, Zn, Pb, and Cd in reservoir water revealed dependence of Zn and Cd on pH and alkalinity, while Ni and Pb were only dependent on pH.
Toxic metals and phthalates are introduced in the manufacturing of plastic toys and modeling clays. In Lebanon, inexpensive plastic toys and modeling clays (sold in dollar stores) are affordable and popular, and there is no legislation to monitor or regulate such toys. This study aimed to assess the quality of inexpensive plastic toys and modeling clays imported in Lebanon. Metal concentrations in toys, namely, zinc [not detectable (ND) to 3,708 μg/g], copper (ND to 140), chromium (ND to 75 μg/g), tin (ND to 39 μg/g), and cadmium (Cd) (ND to 20 μg/g), were lower than the European Union (EU) Directive limits, whereas lead (ND to 258 μg/g) in 10% of samples and antimony (Sb) (ND to 195 μg/g) in 5% of samples were greater than the EU limits. In modeling clays, most of the metals were lower than the EU Directive limits except for Cd and arsenic (As). Cd was detected in 83% of samples, with a mean level of 9.1 μg/g, which is far greater than the EU Directive limit (1.9 μg/g). The As mean level of 4.5 μg/g was greater than the EU limit (4.0 μg/g) and was detected in 9% of samples. Phthalic acid esters (PAEs) were found in 60% of children's toys and 77% of modeling clays. Phthalic acid butyl ester had the highest-level PAE encountered and was ≤59.1 % in one type of clay. However, among children's toys, di(4-octyl) ester terephthalic acid was the highest encountered phthalate at a concentration of 25.7%. The community survey indicated that 82% of households purchase their toys from inexpensive shops and that only 17% of parents were aware of the health hazard of such toys. Consequently, an intervention plan was proposed for the provision of safe toys to children.
The Qaraaoun Reservoir (impoundment of the River Litani) is the only artificial surface water body in the country, Lebanon. Earlier study on the water quality of the Qaraaoun Reservoir identified three water quality zoning with a central distinct zone suitable for multipurpose water usage. The objective of this study was to extend the earlier work by considering the total metal content of reservoir bed sediments and hence to evaluate factors that control metal deposition or capture. Water samples were collected from 15 sampling sites and sediment samples were simultaneously collected from 9 sites. Water parameters analyzed were pH, Eh, DO and temperature. Sediment samples were dried and sieved and sediment < 75 microm was retained for analysis. Sediments were subjected to a stepwise heating process with aqua regia to extract the metals, and their content in sediments determined by ICP-MS. The sediment data revealed higher metal contents where the river entered the reservoir which matched higher concentrations of water parameters at the influx site. Regression analysis of total metals in sediments with distance from the river Litani influx point to the dam revealed a log trend for Fe, Cr and Ni, whereas, the concentrations of Cu, Zn, Cd, Pb were better described by a polynomial regression. Three sediment zones were identified: entrance, oxidation (central) and reducing (near dam) zones. Sediment contents of Zn, Cu and Pb correlated with organic content, whereas sediment Cr and Ni were associated with iron. It was concluded that sediments act as a sink for metals and the deposition of metals is primarily related to sediment organic content and the level of dissolved oxygen in water.
No abstract
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.