We present an X-ray photoelectron spectroscopic (XPS) investigation of potential screening across two gold electrodes fabricated on a porous polymer surface which is impregnated with the ionic liquid (IL) N-N-diethyl-N-methyl-N-(2-methoxyethyl)ammonium bis(trifluoromethanesulfonyl)imide [DEME-TFSI]. The IL provides a sheet of conducting layers to the insulating polymer film, and allows monitoring charging and screening dynamics at the polymer + IL/vacuum interface in a laterally resolved fashion across the electrodes. Time-resolved measurements are also implemented by recording F1s peaks of the IL, while imposing 10 mHz square-wave (SQW) pulses across the two electrodes in a source-drain geometry. Variations in the F1s binding energy reflect directly the transient local electrical potential, and allow us to visualize screening of the otherwise built-in local voltage drop on and across the metal electrodes in the range of millimeters. Accordingly, the device is partitioned into two oppositely polarized regions, each following polarization of one electrode through the IL medium. On the other extreme, upon imposing relatively fast 1 kHz SQW pulses the charge screening is prevented and the device is brought to assume a simple resistor role. A simple equivalent circuit model also reproduces the observed voltage transients qualitatively. The presented structure and variants of XPS measurements, enabling us to record voltage transients in unexpectedly large lateral distances away from the electrodes, can impact the understanding of various electrochemical concepts.

Gold nanoparticles (Au NPs) have been electrochemically prepared in situ and in vacuo using two different electrochemical device configurations, containing an ionic liquid (IL), N-N-diethyl-N-methyl-N-(2-methoxyethyl)ammonium bis(trifluoromethanesulfonyl)imide, that serves both as reaction and as stabilizing media for the NPs. It was observed in both devices that Au NPs were created using an anodically triggered route. The created Au NPs are relatively small (3–7 nm) and reside within the IL medium. X-ray photoelectron spectroscopy is utilized to follow not only the formation of the NPs but also their charging/discharging properties, by monitoring the charging shifts of the Au4f peak representing the electrodes and also the Au NPs as well as the F1s peak of the IL after polarizing one of the electrodes. Accordingly, DC polarization across the electrodes leads to a uniform binding energy shift of F1s of the IL along with that of Au4f of the NPs within. Moreover, this shift corresponds to only half of the applied potential. AC polarization brings out another dimension for demonstrating further the harmony between the charging/discharging property of the IL medium and the Au NPs in temporally and laterally resolved fashions. Polarization of the electrodes result in perfect spectral separation of the Au4f peaks of the NPs from those of the metal in both static (DC) and in time- and position-dependent (AC) modes.

Under application of a voltage bias, asymmetric ion movement of an ionic liquid (IL) through a multilayered graphene (MLG) electrode has been detected by X-ray photoelectron spectroscopy, via recording the intensity of the two nitrogen peaks. Accordingly, we observe that upon increasing the bias, the two peaks representing the cationic and anionic fragments of the IL start appearing with increasing intensity, together with an asymmetry in their ratio, differing from unity by about 10%. Bias-dependent binding energy shifts followed through atomic features of the IL (F 1s, N 1s, and C 1s) and the graphene electrode (C 1s) indicate that a distinct solid−liquid interface develops throughout the entire intercalation process with an additional and pertinent evidence for finite potential drops across the two electrical double layers. This evidence is bolstered by the fact that the measured binding energy difference between the F 1s of the liquid and C 1s peak of the semisolid MLG electrode is only about half of the applied bias, where the rest of the applied voltage is screened by the two electrical double layers at the solid−liquid interfaces between (i) the MLG−IL and (ii) IL−bottom metal electrode. A simple electrostatic estimation indicates that even this small 10% ion imbalance would lead to 4 orders of magnitude larger voltage development between the IL and the MLG phases and suggests the need for amendment(s) to the current understanding of the dielectric description of ILs.

Rough structures with re-entrant property and their subsequent surface energy reduction with long-chain fluorocarbon oligomers are both critical in developing superamphiphobic (SAP, i.e. both super hydrophobic and superoleophobic) surfaces. However, morphology of the lowsurface energy layer on a rough re-entrant substrate can strongly depend on the fluorocarbon oligomers used. In this study, the effect of polar end of different kinds of long-chain fluorocarbon oligomers in promoting a self-assembled monolayer with close packed molecules and robust adhesion on multi-scale rough Al alloy surfaces was investigated. Hierarchical Al alloy surfaces with microgrooves and nanograss structures were developed by a simple combination of one-directional mechanical sanding and post treatment in boiling de-ionized

Thin deposits of aligned semiconducting titanium oxide and of zinc oxide nanowires are prepared by grazing incidence spraying on transparent substrates. By measuring the transmittance of linearly polarized light of...

The understanding of fundamental processes in liquids and at the liquid/electrode interfaces of electrochemical systems is crucial for the development of new devices and technologies with higher efficiency and improved performance. However, it is generally difficult to isolate and study the component of interest in such complex systems. Additionally, ex situ analyses do not always reflect the same properties under operating conditions. Hence, operando characterization tools are required for observing related electrical and chemical processes directly at the places where and while they occur. Operando x-ray photoelectron spectroscopy (o-XPS) has been used, while the sample is imposed to DC/AC voltage stress, to record the binding energy shifts in and on liquids and their interfaces to extract local potentials, as well as many related properties specific to the application in a noncontact and chemically resolved fashion. The applications of o-XPS to low-volatile liquids shown in this review span well-defined studies of (1) electrochemical cells, (2) double-layer capacitors, and (3) electrowetting on dielectrics. The methodology and several applications selected from the authors' recent publications are presented.

XPS monitors the re-orientation of the anionic and cationic fragments with in an ionic liquid at the electrified interface.

No abstract