Investigations were carried out to compare the effectiveness of compounds such as sodium nitrite, trisodium citrate (TSC) and TSC-zinc acetate to inhibit the corrosion of steel rebar in simulated concrete interstitial solution contaminated with chloride and to explain the mechanism of corrosion inhibition on reinforcing steel by these systems. Inhibition efficiency of these systems was studied by electrochemical techniques such as potentiodynamic polarization and half cell potential measurements. Electronic spectral studies of simulated pore solution and FT-IR spectral investigations of the film deposited on steel surface were carried out for understanding the mechanism of corrosion inhibition. Microscopic surface analysis was conducted to obtain the surface morphological behaviour of steel rebar. TSC alone was not exhibited good corrosion inhibition at very low and high concentrations according to electrochemical studies. However, in the presence of zinc acetate, corrosion protection efficiency of TSC increased appreciably. When comparing with sodium nitrite, TSC in the presence and absence of zinc acetate displayed good corrosion inhibition efficiency. Among a number of samples, TSC 100 ppm-zinc acetate 50 ppm combination showed maximum corrosion inhibition efficiency on steel rebar in simulated concrete interstitial solution.
Zinc oxide (ZnO) and nano-zinc oxide (nZnO) were surface modified by polyethylene glycol (PEG) and poly propylene glycol (PPG). Modification of particles were controlled by transmission electron microscopy, Brunauer, Emmett, Teller specific surface area measurement, infrared (IR) spectroscopy, and differential scanning calorimetry. IR spectra were shown that the interactions between surface modifiers and particles are hydrogen bonding. Modified particles were applied as an activator in vulcanization of natural rubber/styrene butadiene rubber (NR/SBR) blend. Dispersion of modified particles in rubber matrix was investigated by scanning electron microscopy and shown good results. Blend properties were improved by using modified particles. These improvements were due to the better hydrophobicity of modified particles, which were more compatible with nonpolar rubber matrix and caused better participation in curing process. Modification by PEG and PPG were shown better compound properties for ZnO and nZnO, respectively. Application of ZnO-modified particles were presented better compound properties in comparison with nZnO-modified particles. It has confirmed more effective mixing of ZnO-modified particles in rubber matrix by using ordinary mixers.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.