Tendons must be able to withstand the forces generated by muscles and not fail. Accordingly, a previous comparative analysis across species has shown that tendon strength (
i
.
e
., failure stress) increases for larger species. In addition, the elastic modulus increases proportionally to the strength, demonstrating that the two properties co-vary. However, some species may need specially adapted tendons to support high performance motor activities, such as sprinting and jumping. Our objective was to determine if the tendons of kangaroo rats (k-rat), small bipedal animals that can jump as high as ten times their hip height, are an exception to the linear relationship between elastic modulus and strength. We measured and compared the material properties of tendons from k-rat ankle extensor muscles to those of similarly sized white rats. The elastic moduli of k-rat and rat tendons were not different, but k-rat tendon failure stresses were much larger than the rat values (nearly 2 times larger), as were toughness (over 2.5 times larger) and ultimate strain (over 1.5 times longer). These results support the hypothesis that the tendons from k-rats are specially adapted for high motor performance, and k-rat tendon could be a novel model for improving tissue engineered tendon replacements.
It is believed that the proposed model has the potential ability to get close to reality in this type of investigation. The proposed function has implications for use in further modelling studies as a heat generation source.
Backpacks cause some bad effects on kinematics of gait. In this study, by testing modified backpacks, some improvements were seen, specifically in posture, which may be useful to reduce side effects of backpack carrying.
The force–velocity (F–V) properties of isolated muscles or muscle fibers have been well studied in humans and other animals. However, determining properties of individual muscles in vivo remains a challenge because muscles usually function within a synergistic group. Modeling has been used to estimate the properties of an individual muscle from the experimental measurement of the muscle group properties. While this approach can be valuable, the models and the associated predictions are difficult to validate. In this study, we measured the in situ F–V properties of the maximally activated kangaroo rat plantarflexor group and used two different assumptions and associated models to estimate the properties of the individual plantarflexors. The first model (Mdl1) assumed that the percent contributions of individual muscles to group force and power were based upon the muscles' cross-sectional area and were constant across the different isotonic loads applied to the muscle group. The second model (Mdl2) assumed that the F–V properties of the fibers within each muscle were identical, but because of differences in muscle architecture, the muscles' contributions to the group properties changed with isotonic load. We compared the two model predictions with independent estimates of the muscles' contributions based upon sonomicrometry measurements of muscle length. We found that predictions from Mdl2 were not significantly different from sonomicrometry-based estimates while those from Mdl1 were significantly different. The results of this study show that incorporating appropriate fiber properties and muscle architecture is necessary to parse the individual muscles' contributions to the group F–V properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.