Geopolymer concrete's workability and compressive strength were investigated by changing the ratio of alkali activators to each other (Na2SiO3/NaOH), the ratio of total solutions to fly ash, and the water content of aggregate. According to the findings, the saturated surface dry condition of the aggregate, in terms of water content in general, increases the workability and compressive strength. In addition, because of the reduction of the Na2SiO3/NaOH ratio, the concrete sets and solidifies faster, and the compressive strength and modulus of elasticity increase. Increasing the ratio of total solutions to fly ash prolongs the setting time but decreases the strength and elasticity modulus and increases the strain corresponding to the maximum stress. As a result, the strain corresponding to the maximum compressive strength of geopolymer concrete is higher, and the modulus of elasticity is lower than that of ordinary portland cement concrete.
Modeling the surface element and support system in deep excavation pits and investigating the deformation mechanism is an important issue. In this study, alternative solution methods for an anchored bored pile model are compared and discussed, and it is aimed to contribute to the studies to be carried out in the deep excavation area. A numerical analysis of retaining wall design is analyzed in the case of the Sivas cultural center building's deep excavation using GGU-Retain and Plaxis 2D software. Measured field data and simulated results are discussed. As a result, the bending moment and lateral deformation reach a maximum when the foundation pit is excavated to the bottom. It can be said that the lateral deformation value found with Plaxis 2D is within the allowable limits, closer to the field data, and provides sufficient quality. The research results will provide theoretical and practical experience for the optimal design and construction of similar deep excavation pits.
Çimento üretiminde bacalardan atmosfere salınan CO2 gazı, küresel ısınmaya neden olmakta ve çevreyi tehdit etmektedir. Bu nedenle bilim insanları, karbon emisyonunu en aza indirmek ve inşaat endüstrisindeki Portland çimentosuna olan ihtiyacı azaltmak için uçucu kül bazlı polimerler üzerinde çalışmaktadırlar. Günümüzde, çimentolu harçların yerine, geopolimer harçların kısmi alternatif bir malzeme olarak kullanımı araştırılmaktadır. Bu çalışmada, 40x40x160 mm'lik prizma kalıplara dökülen alkali ve ısı (90 o C) ile aktifleştirilmiş uçucu kül bazlı geopolimer harçlarda zeolit katkısının mekanik özelliklere olan etkisi araştırılmıştır. Öncelikle "İsken Su gözü Enerji Santrali"'nden alınan F tipi uçucu kül, aktivatör olarak NaOH (%98 saflıkta) ve Na2SiO3 (%50 saflıkta) ile Rilem-Cembureau Standart kumu çeşitli oranlarda karıştırılarak dayanımı en yüksek olan zeolitsiz geopolimer karışım oranları tespit edilmiştir. Ardından en yüksek dayanıma sahip geopolimer harç içindeki uçucu külün ağırlıkça çeşitli oranlarında zeolit katkısı yapılmıştır. Farklı miktarlardaki zeolit katkısı ile eğilme ve basınç dayanımlarını arttırabilmek için karışımdaki alkali aktivatör ve alümina silikat miktarları da değiştirilerek deneyler yapılmıştır. Araştırma sonunda tüm numunelerin bir günlük eğilme ve basınç dayanımları belirlenmiş ve geopolimer harç içine katkı olarak zeolit ilave edilmesi dayanımı arttırıcı mukavemet parametrelerini vermese de zeolitlerin, ağır metal iyonlarını yok etme özelliklerinden dolayı çimentoya göre daha düşük çevresel zararlı etki barındıran yeşil yapı harçları olarak kullanılabileceği bulunmuştur.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.