Numerous cities face the serious problems of rapid urbanization and climate change, especially in recent years. Among all cities, Wuhan is one of the most affected by these changes, accompanied by the transformation of water surfaces into urban lands and the decline of natural ventilation. This study investigated the impact of surface urban heat island enlargement (SUHI) and block morphology changes in heat balance. Accordingly, the interactive impact of building diversity with major building forms (low-rise, mid-rise, and high-rise) on thermal balance and microclimate changes under the influence of urban land expansion at the residential block scale was studied. To investigate the heat balance changes by air temperature intensification and air movement reduction, a long-term and field observational analysis (1980–2018) coupled with computational fluid dynamic simulation (CFD) was used to evaluate the impact of building diversity on thermal balance. Outcomes show that urban heat island intensity (UHII) increased by 2 ℃ when water surfaces in urban areas decreased; consequently, there was a deterioration in the air movement to alleviate UHII. Thus, the air movement declined substantially with UHII and SUHI enlargement, which, through increased urban surfaces and roughness length, will become worse by 2020. Furthermore, the decline in air movement caused by the transformation of urban water bodies cannot contribute to the heat balance unless reinforced by the morphology of the urban blocks. In the design of inner-city blocks, morphological indicators have a significant impact on microclimate and heat balance, where increasing building density and plot ratio will increase UHII, and increasing water surfaces will result in an increase in urban ventilation. Lastly, a substantial correlation between air temperature and relative humidity was found, which, together with the block indicators, can help control the air temperature and adjust the urban microclimate.

To date, studies of outdoor thermal comfort (OTC) have focused primarily on physical factors, tending to overlook the relevance of individual adaptation to microclimate parameters through psychological and physiological behaviors. These adaptations can significantly affect the use of urban and outdoor spaces. The study presented here investigated these issues, with a view to aiding sustainable urban development. Measurements of OTC were taken at a university campus and in urban spaces. Simultaneously, a large-scale survey of thermal adaptability was conducted. Two groups were selected for investigation in a cold-winter-and-hot-summer (CWHS) region; respondents came from humid subtropical (Cfa) and hot desert (BWh) climates, according to the Köppen Climate Classification (KCC). Results showed that: (1) neutral physiological equivalent temperature (NPET) and preferred PET for people from the Cfa (PCfa) and BWh (PBWh) groups could be obtained with KCC; (2) PCfa adaptability behaviors were, subjectively, more adjustable than PBWh; (3) Clothing affected neutral temperature (NT), where NT reduced by approximately 0.5 °C when clothing insulation rose 0.1 Clo; and (4) Gender barely affected thermal acceptance vote (TAV) or thermal comfort vote (TCV) and there was a substantial relationship between thermal sensation, NT, and PET. These findings suggest ‘feels like’ temperature and comfort may be adjusted via relationships between microclimate parameters.

No abstract

Quantifying the energy consumption of buildings is a complex and multi-scale task, with the entire process dependent on input data and urban surroundings. However, most urban energy models do not account for the urban environment. This paper employs a physical-based, bottom-up method to predict urban building operating energy consumption, using imported topography to consider shading effects on buildings. This method has proven to be feasible and aligned well with the benchmark. Research also suggests that commercial and transport buildings have the highest energy use intensity, significantly more than residential and office buildings. Specifically, cooling demands far outweigh heating demands for these building types. Therefore, buildings in the commercial and transportation sectors would receive greater consideration for energy efficiency and improvements to the cooling system would be a priority. Additionally, the method developed for predicting building energy demand at an urban scale can also be replicated in practice.

Rapid urbanization has led to drastic land-use/cover changes (LUCCs) and urban heat islands (UHIs), negatively altering the urban climate and air quality. LUCC’s significant impacts on human health and energy consumption have inspired researchers to develop nature-based solutions to mitigate UHIs and improve air quality. However, integrating GIS-CFD modeling for urban heat mitigation towards climate change adaptation was largely neglected for eco-sustainable urban design in rapidly urbanizing areas. In this study, (1) long-term LUCC and meteorological analyzes were conducted in the Wuhan metropolitan area from 1980 to 2016; (2) to mitigate the adverse effects of LUCC under a speedy development process, the role and relevance of optimizing building morphology and urban block configuration were discussed; (3) and particular design attention in strategy towards climate change adaptation for environmental performance improvement was paid in Wuhan’s fast-growing zones. The results show that UHII in 1980 was less severe than in 2016. Air temperature (Ta) increased by 0.4 °C on average per decade in developing areas. This increases the severity of UHII in urban fringes. It is found obligatory for a nature-based design to adopt urban morphology indicators (UMIs) such as average building height (μBH), sky view factors (ψSVF), and building density (BD/λp = % of built area) towards these changes. Further, on-site measurement revealed that λp is the most effective indicator for increasing urban heat around the buildings and boosting UHII. Using UMIs and a combined three-in-one regulation strategy based on μBH of common building types of high-rise (BHA), mid-rise (BHB), and low-rise (BHC) buildings can effectively contribute to regulating Ta and air movement within block configuration. As a result of this study’s strategy, urban heat is mitigated via reinforcing wind in order to adapt to climate change, which impacts the quality of life directly in developing areas.