The detection of biological molecules and their interactions is a significant component of modern biomedical research. In current biosensor technologies, simultaneous detection is limited to a small number of analytes by the spectral overlap of their signals. We have developed an NMR-based xenon biosensor that capitalizes on the enhanced signal-to-noise, spectral simplicity, and chemical-shift sensitivity of laser-polarized xenon to detect specific biomolecules at the level of tens of nanomoles. We present results using xenon ''functionalized'' by a biotin-modified supramolecular cage to detect biotin-avidin binding. This biosensor methodology can be extended to a multiplexing assay for multiple analytes.R ecent biosensor technologies exploit surface plasmon resonance (1), fluorescence polarization (2), and fluorescence resonance energy transfer (3) as detection methods. Although the sensitivity of such techniques is excellent, extending these assays to multiplexing capabilities has proven challenging because of the difficulty in distinguishing signals from different binding events. Although NMR spectroscopy is able to finely resolve signals from different molecules and environments, the spectral complexity and low sensitivity of NMR spectroscopy normally preclude its use as a detector of molecular targets in complex mixtures. Notable successes (4, 5) in the application of NMR to such problems are still limited by long acquisition times or a limited number of detectable analytes. Laser-polarized xenon NMR benefits from good signal-to-noise and spectral simplicity with the added advantage of substantial chemical-shift sensitivity.Optical pumping (6) has enhanced the use of xenon as a sensitive probe of its molecular environment (7,8). Laserpolarized xenon is being developed as a diagnostic agent for medical magnetic resonance imaging (9) and spectroscopy (10) and as a probe for the investigation of surfaces and cavities in porous materials and biological systems. Xenon provides information both through direct observation of its NMR spectrum (11)(12)(13)(14)(15)(16)(17) and by the transfer of its enhanced polarization to surrounding spins (18,19). In a protein solution, weak xenonprotein interactions render the chemical shift of xenon dependent on the accessible protein surface and even allow the monitoring of the protein conformation (20). To use xenon as a specific sensor of molecules, it would be valuable to ''functionalize'' the xenon for the purpose of reporting specific interactions with a molecular target.In this report, we demonstrate an example of such a functionalized system that exhibits molecular target recognition. Fig. 1 shows the chemical principle used for our initial study, a biosensor molecule designed to bind both xenon and protein.The molecule consists of three parts: the cage, which contains the xenon; the ligand, which directs the functionalized xenon to a specific protein; and the tether, which links the ligand and the cage. The ligand and target can be any two molecules or constructs. In su...

NMR-based biosensors that utilize laser-polarized xenon offer potential advantages beyond current sensing technologies. These advantages include the capacity to simultaneously detect multiple analytes, the applicability to in vivo spectroscopy and imaging, and the possibility of "remote" amplified detection. Here we present a detailed NMR characterization of the binding of a biotin-derivatized caged-xenon sensor to avidin. Binding of "functionalized" xenon to avidin leads to a change in the chemical shift of the encapsulated xenon in addition to a broadening of the resonance, both of which serve as NMR markers of ligand-target interaction. A control experiment in which the biotin-binding site of avidin was blocked with native biotin showed no such spectral changes, confirming that only specific binding, rather than nonspecific contact, between avidin and functionalized xenon leads to the effects on the xenon NMR spectrum. The exchange rate of xenon (between solution and cage) and the xenon spin-lattice relaxation rate were not changed significantly upon binding. We describe two methods for enhancing the signal from functionalized xenon by exploiting the laser-polarized xenon magnetization reservoir. We also show that the xenon chemical shifts are distinct for xenon encapsulated in different diastereomeric cage molecules. This demonstrates the potential for tuning the encapsulated xenon chemical shift, which is a key requirement for being able to multiplex the biosensor.

A technique is proposed in which an NMR spectrum or MRI is encoded and stored as spin polarization and is then moved to a different physical location to be detected. Remote detection allows the separate optimization of the encoding and detection steps, permitting the independent choice of experimental conditions and excitation and detection methodologies. In the initial experimental demonstration of this technique, we show that taking dilute 129 Xe from a porous sample placed inside a large encoding coil and concentrating it into a smaller detection coil can amplify NMR signal. In general, the study of NMR active molecules at low concentration that have low physical filling factor is facilitated by remote detection. In the second experimental demonstration, MRI information encoded in a very low-field magnet (4 -7 mT) is transferred to a high-field magnet (4.2 T) to be detected under optimized conditions. Furthermore, remote detection allows the utilization of ultrasensitive optical or superconducting quantum interference device detection techniques, which broadens the horizon of NMR experimentation.

The high sensitivity of the magnetic resonance properties of xenon to its local chemical environment and the large 129 Xe NMR signals attainable through optical pumping have motivated the use of xenon as a probe of macromolecular structure and dynamics. In the present work, we report evidence for nonspecific interactions between xenon and the exterior of myoglobin in aqueous solution, in addition to a previously reported internal binding interaction.

No abstract

We have created a stable bicelle system capable of forming micrometer-scale lipid domains that orient in a magnetic field, suitable for structural biology determination in solid-state NMR. The bicelles consisted of a mixture of cholesterol, saturated lipid (DMPC), and unsaturated lipid (POPC), a mixture commonly used to create domains in model membranes, along with a short chain lipid (DHPC) that allows formation of the bicelle phase. While maintaining a constant molar ratio of long to short chain lipids, q = ([POPC]+[DMPC])/[DHPC] = 3, we varied the concentrations of the unsaturated lipid, POPC, and cholesterol to observe the effects of the components on bicelle stability. Using (31)P solid-state NMR, we observed that unsaturated lipids (POPC) greatly destabilized the alignment of the membranes in the magnetic field, while cholesterol stabilized their alignment. By combining cholesterol and unsaturated lipids in the bicelles, we created membranes aligning uniformly in the magnetic field, despite very high concentrations of unsaturated lipids. These bicelles, with high concentrations of both cholesterol and unsaturated lipid, showed similar phase behavior to bicelles commonly used in structural biology, but aligned over a wider temperature range (291-314 K). Domains were observed by measuring time-dependent diffusion constants reflecting restricted diffusion of the lipids within micrometer-scale regions of the bicelles. Micron-scale domains have never been observed in POPC/DMPC/cholesterol vesicles, implying that bilayers in bicelles show different phase behavior than their counterparts in vesicles, and that bilayers in bicelles favor domain formation.

No abstract

No abstract