A rigorous evaluation of future hydro-climatic changes is necessary for developing climate adaptation strategies for a catchment. The integration of future climate projections from general circulation models (GCMs) in the simulations of a hydrologic model, such as the Soil and Water Assessment Tool (SWAT), is widely considered as one of the most dependable approaches to assess the impacts of climate alteration on hydrology. The main objective of this study was to assess the potential impacts of climate alteration on the hydrology of the Yarra River catchment in Victoria, Australia, using the SWAT model. The climate projections from five GCMs under two Representative Concentration Pathway (RCP) scenarios—RCP 4.5 and 8.5 for 2030 and 2050, respectively—were incorporated into the calibrated SWAT model for the analysis of future hydrologic behaviour against a baseline period of 1990–2008. The SWAT model performed well in its simulation of total streamflow, baseflow, and runoff, with Nash–Sutcliffe efficiency values of more than 0.75 for monthly calibration and validation. Based on the projections from the GCMs, the future rainfall and temperature are expected to decrease and increase, respectively, with the highest changes projected by the GFDL-ESM2M model under the RCP 8.5 scenario in 2050. These changes correspond to significant increases in annual evapotranspiration (8% to 46%) and decreases in other annual water cycle components, especially surface runoff (79% to 93%). Overall, the future climate projections indicate that the study area will become hotter, with less winter–spring (June to November) rainfall and with more water shortages within the catchment.

Solar disinfection (SODIS) is a simple and low-cost household water treatment (HWT) option used for disinfection of drinking water. In this study, the bacterial inactivation potential of SODIS was evaluated under the solar irradiance observed in different seasons in Bangladesh according to WHO evaluation protocol of HWT, and the SODIS experiments were conducted for both transmissive and reflective reactors using PET bottles and plastic bags. In summer, log reduction value (LRV) more than 5 was observed for the transmissive PET reactors for 6 to 8 hr exposure to sunlight and the treated water complied with the microbial standard of zero colony forming units/100 mL in drinking water. In monsoon and winter, LRV > 4 can be achieved for 16 hr and 8 hr exposure to sunlight, respectively, using reflective reactors. The plastic bag was found more effective than PET. A safe exposure time was estimated from the Weibull model to be maintained for SODIS application to achieve 4.0 LRV and also to prevent the re-growth of microorganisms into the treated water. A significant re-growth of microorganisms was observed in the treated water, thus SODIS with other HWT processes can be recommended for use in communities having an unsafe drinking water supply.

Potable and equitable drinking water (DW) is a fundamental human right and essential for human health. This study is conducted to assess the groundwater and jar water quality of the roadside restaurants and tea stalls used for drinking by the local people around the Gazipur City area in Bangladesh. Water samples from 173 restaurants and tea stalls are collected. The physico-chemical and biological parameters are analyzed according to the guidelines and standards. The results illustrate that the color, EC, and Mn of 41%, 80%, and 62% of the samples, respectively, exceed the WHO and Environmental Conservation Rules (ECR) standards. In addition, E. coli and total coliform exceeding the threshold standards are found in 47% and 64% of the water samples, respectively. The contamination of DW by fecal coliforms is confirmed and supported by prior studies, which indicates that the DW supplied in restaurants and tea stalls are unsafe because of the possible presence of pathogens. These may cause potential health hazards to consumers from various water-borne diseases. Poor sanitation, unhygienic practices, and improper disposal of wastewater are responsible for the microbial contamination of DW. So, the authorities in charge of these places should take the right regulatory steps, such as regular sanitation inspections, DW quality monitoring, hand-washing practices, and better sanitation in these places.

Pollution of a watershed by different land uses and agricultural practices is becoming a major challenging factor that results in deterioration of water quality affecting human health and ecosystems. Sustainable use of available water resources warrants reduction of Non-Point Source (NPS) pollutants from receiving water bodies through best management practices (BMPs). A hydrologic model such as the Soil and Water Assessment Tool (SWAT) can be used for analyzing the impacts of various BMPs and implementing of different management plans for water quality improvement, which will help decision makers to determine the best combination of BMPs to maximize benefits. The objective of this study is to assess the potential reductions of sediments and nutrient loads by utilizing different BMPs on the Yarra River watershed using the SWAT model. The watershed is subdivided into 51 sub-watersheds where seven different BMPs were implemented. A SWAT model was developed and calibrated against a baseline period of 1998–2008. For calibration and validation of the model simulations for both the monthly and annual nutrients and sediments were assessed by using the Nash–Sutcliffe efficiency (NSE) statistical index. The values of the NSE were found more than 0.50 which indicates satisfactory model predictions. By utilizing different BMPs, the highest pollution reduction with minimal costs can be done by 32% targeted mixed-crop area. Furthermore, the combined effect of five BMPs imparts most sediments and nutrient reductions in the watershed. Overall, the selection of a BMP or combinations of BMPs should be set based on the goals set in a BMP application project.