The controlled production of single photons is of fundamental and practical interest; they represent the lowest excited quantum states of the radiation field, and have applications in quantum cryptography and quantum information processing. Common approaches use the fluorescence of single ions, single molecules, colour centres and semiconductor quantum dots. However, the lack of control over such irreversible emission processes precludes the use of these sources in applications (such as quantum networks) that require coherent exchange of quantum states between atoms and photons. The necessary control may be achieved in principle in cavity quantum electrodynamics. Although this approach has been used for the production of single photons from atoms, such experiments are compromised by limited trapping times, fluctuating atom-field coupling and multi-atom effects. Here we demonstrate a single-photon source based on a strongly localized single ion in an optical cavity. The ion is optimally coupled to a well-defined field mode, resulting in the generation of single-photon pulses with precisely defined shape and timing. We have confirmed the suppression of two-photon events up to the limit imposed by fluctuations in the rate of detector dark counts. The stream of emitted photons is uninterrupted over the storage time of the ion, as demonstrated by a measurement of photon correlations over 90 min.

In near-field imaging, resolution beyond the diffraction limit of optical microscopy is obtained by scanning the sampling region with a probe of subwavelength size. In recent experiments, single molecules were used as nanoscopic probes to attain a resolution of a few tens of nanometres. Positional control of the molecular probe was typically achieved by embedding it in a crystal attached to a substrate on a translation stage. However, the presence of the host crystal inevitably led to a disturbance of the light field that was to be measured. Here we report a near-field probe with atomic-scale resolution-a single calcium ion in a radio-frequency trap-that causes minimal perturbation of the optical field. We measure the three-dimensional spatial structure of an optical field with a spatial resolution as high as 60 nm (determined by the residual thermal motion of the trapped ion), and scan the modes of a low-loss optical cavity over a range of up to 100 microm. The precise positioning we achieve implies a deterministic control of the coupling between ion and field. At the same time, the field and the internal states of the ion are not affected by the trapping potential. Our set-up is therefore an ideal system for performing cavity quantum electrodynamics experiments with a single particle.

No abstract

In this paper we propose to utilize the X 2 g (ν,N,F,M) = (0,0,1/2, ±1/2) → (1,0,1/2, ±1/2) or (2,0,1/2, ±1/2) transition of N 2 + (I = 0) to test variations of the proton-to-electron mass ratio. The X 2 g ground state exhibits no quadrupole shift and the Zeeman shift of the N = 0 → N = 0 transition is exactly zero. Because N 2 + is nonpolar, systematic level shifts such as Stark shifts induced by trap electric field or blackbody radiation are very small and the thermalization of the rotational states is inhibited. This eases the requirements on the experimental setup significantly. Employing Raman transitions at the "magic" wavelength the (0,0,1/2, ±1/2) → (1,0,1/2, ±1/2) or (2,0,1/2, ±1/2) transition frequency can be measured very precisely.

No abstract

Strong coupling between an atom and an electromagnetic resonator is an important condition in cavity quantum electrodynamics (QED). While strong coupling in various physical systems has been achieved so far, it remained elusive for single atomic ions. In this paper we demonstrate for the first time the coupling of a single ion to an optical cavity with a coupling strength exceeding both atomic and cavity decay rates. We use cavity assisted Raman spectroscopy to precisely characterize the ion-cavity coupling strength and observe a spectrum featuring the normal mode splitting in the cavity transmission due to the ion-cavity interaction. Our work paves the way towards new applications of cavity QED utilizing single trapped ions in the strong coupling regime for quantum optics and quantum technologies.

Trapped atomic ions are ideal single photon emitters with long-lived internal states which can be entangled with emitted photons. Coupling the ion to an optical cavity enables the efficient emission of single photons into a single spatial mode and grants control over their temporal shape. These features are key for quantum information processing and quantum communication. However, the photons emitted by these systems are unsuitable for long-distance transmission due to their wavelengths. Here we report the transmission of single photons from a single ^{40}Ca^{+} ion coupled to an optical cavity over a 10 km optical fiber via frequency conversion from 866 nm to the telecom C band at 1530 nm. We observe nonclassical photon statistics of the direct cavity emission, the converted photons, and the 10 km transmitted photons, as well as the preservation of the photons' temporal shape throughout. This telecommunication-ready system can be a key component for long-distance quantum communication as well as future cloud quantum computation.

We present a novel method of machining optical fiber surfaces with a CO₂ laser for use in Fiber-based Fabry-Perot Cavities (FFPCs). Previously FFPCs were prone to large birefringence and limited to relatively short cavity lengths (≤ 200 μm). These characteristics hinder their use in some applications such as cavity quantum electrodynamics with trapped ions. We optimized the laser machining process to produce large, uniform surface structures. This enables the cavities to achieve high finesse even for long cavity lengths. By rotating the fibers around their axis during the laser machining process the asymmetry resulting from the laser's transverse mode profile is eliminated. Consequently we are able to fabricate fiber mirrors with a high degree of rotational symmetry, leading to remarkably low birefringence. Through measurements of the cavity finesse over a range of cavity lengths and the polarization dependence of the cavity linewidth, we confirmed the quality of the produced fiber mirrors for use in low-birefringence FFPCs.